RAD Data comm operation manual Configuring IPmux-11 for Operation, Configuring the System Clock

Installation and Operation Manual Chapter 4 Configuration

To select the baud rate:

1.From the System menu (Figure 4-1), select Control port. The Control Port menu is displayed (see Figure 4-11).

2.From the Control Port menu, select Baud rate, and configure baud rate of the IPmux-11 terminal control port to the desired value (9600, 19200, 38400, 57600 or 11520 bps).

Configuration>System>Control port
Data bits		(8)
Parity	>	(None)
Stop bits		(1)
Flow control	>	(None)
1. Baud rate (bps)	>	(115200)
>
Please select item <1 to 1>		1 Mngr/s
ESC-prev.menu; !-main menu; &-exit

Figure 4-11. Control Port Menu

4.3 Configuring IPmux-11 for Operation

Configuring the System Clock

You can configure the parameters of the IPmux-11 system clock, including the master clock and fall back clock. If the clock is adaptive or Rx clock then you can also configure the clock source.

Note	If the configured fallback clock source fails, the internal timing is used as the fallback
	clock source instead.

To configure the system clock:

1.From the System menu (Figure 4-1), select System clock. The System clock menu appears (See Figure 4-12).

2.From the System clock menu, configure the following: Master clock (Master clock type):

Internal Adaptive Rx clock

Master source (Master clock source): Channel 1

Channel 2 Channel 3

IPmux-11 Ver. 2.00 Configuring IPmux-11 for Operation 4-11