Honeywell 40002083 StrobeGuard Control & Status Network Wiring Connections

Airport Systems

b)Next, loosen the plug-in terminal’s screw labeled #2 as shown in Figure 3.3-4sufficiently to insert the PLCHMR module’s Blue wire into this terminal position along with maintaining any existing wiring connections.

c)Finally, sufficiently loosen the plug-in terminal’s screw labeled #4 as shown in Figure 3.3-4and insert the PLCHMR module’s Black wire into the terminal position while maintaining any existing wiring connections.

Reinstall the plug-in terminal onto its corresponding fixed mating header located on the Master Controller.

1	2	3	4
	White Wire			Black Wire
			Blue Wire

Figure 3.3-4 StrobeGuard Control & Status Network Wiring Connections

3.3.4SGF-60-E Flash-head Digital Controller MCU Upgrade

The installation kit provides new MCUs P/N 40002084-001 to replace all existing old MCUs P/N 40000324-001 in Flash Head Logic Control Board. See Figure 2.2-3 for the location of Logic Control Board in the Flash Head Enclosure. It is important to install the MCU with the proper orientation since more often than not installing a MCU backwards will result in damage to the chip and/or surrounding circuitry. First note the location of pin 1. To find pin 1 look for a small rectangular notch on one of its short ends this denotes the top side of MCU; the first pin counter-clockwise from this notch is pin 1.

PLC Health Monitoring & Reporting Sys 3-8 Manual EPM40002083-001 Rev -