ABOUT MEMORY | ABOUT PRESSURE INDICATOR |
The
To retrieve readings, follow these simple steps:
1.When the display screen is blank, press and hold the START button. While holding down the START button, you will see the average reading displayed first. You will then see the memory index number (e.g. n03) of the most recent reading followed by the measurement. Release the START button when you see the memory index number.
2.The display will shut off automatically a few seconds after all of the readings are displayed. To turn off the monitor at any time, press the START button.
3.The display will shut off automatically a few seconds after the readings are displayed.
To clear the measurement history from memory, remove the bat- teries from the unit and then place the batteries back into the bat- tery holder.
NOTE: If there are no measurements stored in memory, you will see two 0s displayed vertically followed by a blinking "A00".
NOTE: Stored measurements will be lost if batteries become low or are removed.
The Pressure Indicator is located on the left side of the display screen to tell you when the blood monitor is inflating the cuff. The indicator consists of a scale with six levels and moves up during inflation.
Inflation in | Inflation/Measurement | Measurement |
Progress | Complete | Displayed |
NOTE: The motor will inflate the cuff at a slow speed starting at 20mmHg to begin the blood pressure measurement process.
LifeSource Health Line | In Canada |