Toro Plus Series Satellite specifications Manual Output Switch Operation, Power Indicator Lamps

Manual Output Switch Operation
A 3-position switch is provided on the Pump/Com
module for additional control of the pump relay
circuit. In addition, the optional station terminal			Field Common
modules with optional control switches have one
switch for each station output.			Engage Switch
The three switch positions control the circuits as			Field Common
follows:			Indicator Lamp
On – Manually activates the circuit. The pump or			Pump Circuit
station will remain on until the switch is moved to the	HOT POST	HOT POST	Switch
Auto or Off position.

Off – Switches the circuit off, preventing pump or	Station Output
station operation from the satellite.
	Control Switches
Auto – The circuit is automatically activated by the
	(Optional)
controller during automatic or manual watering
operation.
As an added lightning protection measure, the field
common circuit is normally open when the controller
is inactive. Therefore, to use the field output control

switches for manual operation, the common circuit must be engaged first. Press the Field Common Engage push button switch to activate the circuit. The Field Common Indicator Lamp will turn on when the circuit is active. The common circuit will automatically disconnect upon completion of an automatic or manually activated watering operation initiated through the timing mechanism. The circuit can also be disconnected by momentarily switching the power supply off.

Caution: To prevent damage to the 3.2A field output circuit fuse, do not exceed 3.2A load when manually activating multiple field outputs.

Power Indicator Lamps

Two indicator lamps, as shown in the illustration at right, are provided to verify the presence of power to the control and field output circuits. In normal operating conditions, both lamps will be On. If both lamps are Off, no power is present. Ensure the power supply/circuit breaker switch is On. Also check the main power source circuit breaker and any additional power disconnection devices in the fixed wiring. If the left indicator lamp is Off, the 4A circuit breaker is open and must be reset. If the right indicator lamp is off, the 3.2A field output fuse is blown.

WARNING

Control Circuit

Indicator Lamp

8-Station Module Retainer Screw

Output Circuit Indicator Lamp

IF FUSE REPLACEMENT IS REQUIRED, REPLACE WITH A FUSE OF THE SAME TYPE AND AMPERAGE RATING. FAILURE TO COMPLY CAN RESULT IN SERIOUS INJURY AND/OR EQUIPMENT DAMAGE DUE TO FIRE HAZARD.

Removing and Installing 8-Station Modules

1.Switch power supply Off

2.Remove single screw from module.

3.Pull module outward from top connector then upward from bottom connector (if installed).

4.Install module in reverse order.

Power Supply

On/Off Switch	4A Control
	Circuit Breaker

Power Supply 5A	3.2A Field
	Output Fuse
Circuit Breaker

Note: When adding modules, utilize the first available open position from left to right, front to back. Do not leave open spaces between modules.

17