Omega Engineering HH507R Operating Instructions, Power Switch, F Selecting the Temperature Scale

Page 7

OPERATING INSTRUCTIONS

1 Power Switch

The key turns the thermometer on or off. In the MIN MAX record mode can not power off, must leave MIN MAX record mode then power off.

2°C/°F Selecting the Temperature Scale

Readings are dual displayed in either degrees Celsius(°C) or degrees Fahrenheit(°F). When the thermometer is turned on, it is set to the temperature scale that was in use when the thermometer was last turned off. To change the temperature scale, press the °C/°F key.

3HOLD Mode (only Main display)

Pressing the HOLD key to enter the Data Hold mode, the "HOLD" annun- ciator is displayed. When HOLD mode is selected, the thermometer held the present readings and stops all further measurements.

Pressing the HOLD key again to cancel HOLD mode causing thermometer to resume taking measurements.

In the MIN/MAX recording mode, press HOLD key to stop the recording. Press HOLD key again to resume recording. (Previously recorded reading are not erased).

5

Image 7
Contents Omega Omega.comTM Introduction Safety InformationElectrical SpecificationsT/E-TYPE Environmental Operating Instructions Power SwitchF Selecting the Temperature Scale Hold Mode only Main displayMIN MAX with Time record Mode only Main display Timer STOP-WATCH ModeJ/T/E/R/S/N T1 Input Thermocouple Type Select Main display REL Relative mode only Main display Hi/Lo Limits mode only Main display 11 Hi/Lo Limits value Recall display mode Relative value Recall display modeButton Battery Replacement Operator MaintenanceRS-232 Operation Using Quick Basic END if CLS Locate 13 RS-232 Transmit and Receive Comammand Summary Output Data Formats LSD MSD Communication HH 506R/HH 507R Calibration Procedure Warranty / Disclaimer 2814/0799