Citizen CH-671F instruction manual If YOU do not Wish to Store Measurement Results

Page 19

HOW TO MEASURE YOUR BLOOD PRESSURE

IF YOU DO NOT WISH TO STORE MEASUREMENT RESULTS

Normally, the measurement results are automatically stored. If you don’t want to store the measurement results, erase them immediately after measurement according to the procedure below.

* Once stored, measurement results cannot be cleared individually.

1 Press and hold for more than 2

seconds while the measurement

results are displayed.

The message for memory clearance (CL) will appear, and the device will automatically turn off the power in 2 seconds.

*This step will permanently delete the measurement results being displayed so that you cannot undo this action to call up them later. Before proceeding, make sure that you want to delete them.

English

- Eng 19 -

Image 19

Contents REF CH-671F For proper measure of blood pressure General RemarksRemarks Precaution for USE and Maintenance Recaution for maintenance Weee Mark Universal Design Identification of PartsHOW to Load Batteries Re-attach the battery box to the unit Pull the battery box to remove from the unitSet the Year HOW to SET the ClockSet the Date Set the MonthSet the Minute Set the HourPoints for Accurate Measurement Loosely fit the wrist cuff by Pulling the end of the cuff HOW to Wrap the Wrist CuffHOW to Wrap the Wrist Cuff Make sure that your posture is correct Wrap the wrist cuff around your left wristHOW to Measure Your Blood Pressure Automatic Power Off Function Press To turn off powerIf YOU do not Wish to Store Measurement Results HOW to Call UP Data Stored in Memory HOW to Call UP Previous Measurement Results HOW to Call UP Monthly Average Data HOW to Call UP Previous Monthly Average Data HOW to Delete ALL Data in Memory About Blood Pressure Questions and Answers on Blood Pressure Display Mark CONDITION/CAUSE Corrective Action Error IndicationsLCD SpecificationsApprox min Before Asking for REPAIR/INSPECTION Mail sales-oe@systems.citizen.co.jp