I V . A S S E M B L Y
INITIAL ASSEMBLY
Your power chair may require some assembly either before initial use or after transportation.
NOTE: Any nylon insert lock nut removed during the disassembly or adjustment of the power chair must be replaced with a new nylon insert lock nut. Nylon insert lock nuts should not be reused as it may cause damage to the nylon insert, resulting in a less secure fit. Replacement nylon insert lock nuts are available at local hardware stores or by contacting your authorized Pride Provider.
Seat Installation
It may be necessary to install the seat either prior to initial operation or after transporting your power chair.
WARNING! Do not pick up the seat frame by the armrests. They are free to pivot, and you may lose control of the seat if they do so.
To install the seat:
1.Adjust the upper seat post to the desired position and insert the bolt through the seat post and secure with the nut. See figure 6.
2.Slide the seat down onto the upper seat post.
See figure 6.
3.Install the controller into one of the armrests. Tighten the setscrew with the supplied hex key. See figure 6.
4.Lift the armrest straight up, then route the controller harness and secure with wire ties as shown in figures 6 and 7.
NOTE: It is important that the armrest be lifted straight up prior to securing the controller harness with wire ties.
MANDATORY! Prevent controller harness damage! Avoid routing the controller harness on the outside of the armrest pad. Route the harness under the armrest or toward the inside of the armrest pad. Use correct
5.Plug the controller harness into the connector on the power base. See figure 2.
SEAT |
CONTROLLER |
SETSCREW |
UPPER SEAT |
POST |
POWER BASE |
Figure 6. Seat and Controller Assembly
WIRE TIES |
WIRE TIES |
Figure 7. Controller Harness Routing
Jazzy Sport 2 | www.pridemobility.com | 11 |