V I I . C A R E A N D M A I N T E N A N C E
3.Remove the seat.
4.Remove the main shroud by lifting the rear of the shroud up and pulling the shroud back. See figure 17.
5.Remove the shipping guard if applicable. See figure 17.
6.Disconnect the battery cables from the battery terminals of each battery. See figure 17.
7.Loosen the yellow thumbscrews and slide the battery tray back.
WARNING! The battery cables must be disconnected from the battery terminals before sliding the battery tray back or cable damage could result.
8.Lift the front and rear batteries out of the power base.
9.Install new batteries into the battery tray. Make sure the terminals of each battery are facing the front of the power chair. See figure 17.
10.Slide the battery tray back into place and tighten the yellow thumbscrews.
11.Connect the front battery cable to the front battery terminals according to the battery wiring diagram. Make sure that the battery terminal hardware is facing the correct direction. See figure 17.
12.Connect the rear battery cable to the rear battery terminals according to the battery wiring diagram. Make sure that the battery terminal hardware is facing the correct direction. See figure 17.
WARNING! Make sure you tighten the fasteners so that the connections are secure.
13.Reinstall the main shroud by aligning the slots in the front of the shroud with the slots in the front cover and then sliding the shroud into place.
14.Reinstall the seat.
15.Charge the batteries. See VI. “Batteries and Charging.”
When to Contact Your Authorized Pride Provider for Service
The following symptoms could indicate a serious problem with your power chair. If necessary, contact your authorized Pride Provider. When calling, have the model number, serial number, nature of the problem, and the error code if available.
Motor noise
Frayed harnesses
Cracked or broken connectors
Uneven wear on any of the tires
Jerky motion
Pulling to one side
Bent or broken wheel assemblies
Does not power up
Powers up, but does not move
Loose seator seating components
Corrective Maintenance
If the battery condition meter does not light up when you turn on the power:
Check the harness connections. Make sure they are tight.
Check the circuit breaker. Reset it if necessary.
Check the battery connections.
If the above conditions prove normal, you can load test the batteries with a battery load tester. These testers are available at automotive parts stores. Disconnect both batteries before load testing and follow the directions that come with the load tester. If either one of the batteries fails the load test, replace both of them. If your power chair still does not power up, contact your authorized Pride Provider.
26 | www.pridemobility.com | Jazzy Sport 2 |