V . C O M F O R T A D J U S T M E N T S
Controller Position
You can move the controller in toward or out away from the armrest, or change the position of the control- ler for either
WARNING! Do not place the controller harness so that it can be pinched in the seat frame or the power base frame.
To extend the controller:
1.Flip up the armrest so it is perpendicular to the floor.
2.Loosen the setscrew on the controller bracket. See figure 10.
3.Slide the controller into or out of the armrest to the desired position.
4.Tighten the setscrew to secure the controller.
To change the controller position:
1.Turn off the power to the controller.
2.Unplug the controller harness from the power base.
3.Cut the wire tie(s) that secure the controller harness to the armrest and seat.
4.Flip up the armrest so it is perpendicular to the floor.
5.Loosen the setscrew on the controller bracket
6.Slide the controller out of the armrest.
7.Loosen the setscrew in the other armrest.
8.Place the controller in the other armrest.
9.Tighten the setscrew to secure the controller.
10.Route the controller harness along the seat frame and secure with wire ties. See figure 7.
11.Plug the controller connector into the power base.
See figure 2.
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform. See figure 11.
To adjust the foot platform angle:
1.Flip up the foot platform and locate the adjustment screw.
2.Turn the adjustment screw to raise or lower the front of the foot platform.
SETSCREW
Figure 10. Underside of Armrest
ADJUSTMENT SCREW |
Figure 11. Foot Platform Angle Adjustment
14 | www.pridemobility.com | Jazzy Sport 2 |