To Install Canopies
Rear canopy | Front canopy |
(with rear flap) | (no flap) |
Before installing the canopies, first identify the front and rear canopies according to the pictures above. Position both
canopies with the large sewn tunnel toward the front.
Rear Canopy:
Step 1.
Snap canopy mounts between rings on plastic sleeves above the armrests.
Step 2.
Fasten two hook tabs on rear canopy flap to the loop tabs on canopy. Repeat on other side.
To remove canopy, reverse above steps.
Front Canopy:
Push both canopy brackets down at the same time into openings on stroller frame.
To Adjust Canopies
Push or pull either canopy to desired position.
Front canopy pivots to the front or to the rear.
To Unfold Stroller
Step 1.
Push down on the storage latch.
Step 2.
Unfold stroller as shown.
Be certain
the stroller is fully erected and latched before allowing your child near the stroller.
To Adjust Seat Backs
Front seat back has one recline position. Rear seat back has three, including fully reclined carriage position.
To recline either the front or rear seat back, push back of seat slightly forward while pulling up on wire as shown to unlock. Recline seat back to the desired position.
Child may slip into leg openings and strangle. Never use rear seat in a reclined carriage position unless closure flap is properly secured.
!Fabric side panels must be snapped at front of both armrests.
!Two lower hook/loop tabs must be threaded through buttonholes in fabric side panels and tightly fastened.
!Two upper hook/loop tabs must be threaded through plastic slots at front of armrests and tightly fastened.
Snaps
Insert tabs through fabric buttonholes and plastic slots
9 | 10 |
