V . C O M F O R T A D J U S T M E N T S
10.Reinstall the retaining clips from step 8.
11.Remove each screw from the trapeze bars and apply thread lock.
12.Reinstall each screw into the trapeze bars and tighten.
13.Reinstall the seat.
14.Reconnect the controller to the power pod.
15.Reinstall the rear shroud and tighten the fasteners.
Seat Position
You can move the seat forward or rearward by changing the extrusion mounting position.
To change the position:
1.Turn off the power to the controller.
2.Loosen the rear shroud fasteners and remove the rear shroud.
3.Unplug the controller connectors from the power pod.
4.Remove the seat from the power base.
5.Remove both extrusions from the bottom of the seat.
6.Reposition the extrusions on a different set of mounting holes. You must move both extrusions the same number of holes either forward or backward. See figure 15.
7.Fasten the extrusions back onto the bottom of the seat.
8.Reinstall the seat.
9.Plug the controller connectors into the power pod.
10.Reinstall the rear shroud and tighten the fasteners.
Seatback Angle Adjustment
If your power chair is equipped with an adjustable seatback, you can adjust it to four (4) different angles: 90°, 102°, 105°, or 107°.
To adjust the seatback angle:
1.Remove the adjusting screws from each seat hinge. See fig- ure 16.
2.Set the seatback at the desired angle.
3. Reinstall the adjusting screws to each seat hinge and tighten.
SEAT MOUNTING HOLES |
Figure 15. Seat Mounting Holes
ARMREST ANGLE ADJUSTING SCREW |
JAM NUT |
SEATBACK |
ANGLE |
ADJUSTING |
SCREW |
ARMREST KNOB |
Figure 16. Seatback Angle Adjustment
24 | www.pridemobility.com | Jazzy 1103 Ultra |