Pride Mobility 1121 owner manual Display Pad, Profile and Speed Indicator, Actuator Indicator

Page 41

V I I . O P E R A T I O N

Display Pad

The display pad is located directly in front of the joystick. It contains the horn key, battery condition meter, profile and speed indicator, and the actuator indicator. See figure 31.

Horn Key

The horn key activates the horn.

Battery Condition Meter

The battery condition meter is a 10-segment illuminated display that indicates that the Microdrive is powered on and also gives the status of the batteries, the controller, and the power chair electrical system.

!Red, yellow, and green lights lit: Batteries charged; controller and electrical system OK.

!Red and yellow lights lit: Charge batteries if possible; controller and electrical system OK.

!Red lights only lit or slow flash: Charge batteries as soon as possible; controller and electrical system OK.

!Rapid flash of lights: Indicates a fault in the controller or the electrical system. See “Error Codes.”

!Ripple up and down of lights: The joystick was not in the neutral position when the controller was turned on. If you get “ripple up and down of lights,” turn off the controller, allow the joystick to return to the neutral position, then turn on the controller.

NOTE: If you still get “ripple up and down of lights,” contact your Quantum Rehab Specialist.

NOTE: When the batteries approach a discharged state, the first red light will begin to slowly flash, reminding you the batteries need to be charged immediately!

Profile and Speed Indicator

The profile and speed indicator is a 5-segment illumi- nated display that indicates speed setting as well as drive profile.

Actuator Indicator

The actuator indicator is a 4-segment illuminated dis- play that indicates power recline, power tilt, power leg rest, and power elevating seat actuator modes.

Joystick Interface Module

The joystick interface module provides a means to enable or disable the horn button, mode switch, on/off switch, and speed adjustment dial.

NOTE: When a toggle switch is set to “J/S,” the joystick has control of a particular function. When the toggle switch is set to “Local,” control of this function is disabled at the joystick.

Figure 31. Microdrive Display Pad

Quantum1121

www.quantumrehab.com

41

Image 41

Contents Page F E T Y G U I D E L I N E S III N T E N T SN T R O D U C T I O N SafetyPURCHASER’S Agreement Information ExchangeMy Quantum Rehab Specialist Pride Owners ClubModifications Pre-Ride Safety CheckS a F E T Y Incline Information Weight LimitationsTire Inflation Outdoor Driving Surfaces Braking InformationCornering Information Public Streets and Roadways Stairs and Escalators Freewheel ModeStationary Obstacles Steps, Curbs, etc Doors TransfersElevators Lift/Elevation ProductsMotor Vehicle Transport Inclement Weather PrecautionsPositioning Belts Reaching and BendingAlcohol BatteriesElectromagnetic and Radio Frequency Interference EMI/RFI Quantum I . Y O U R P O W E R C H a I RSpecifications Quantum 1121 Power Base Active-Trac Suspension Electronics TrayTo operate the dual manual freewheel levers Manual Freewheel LeverA S S E M B L Y Initial AssemblySeat Installation To install the seat Seat Height and Seat Angle Adjustment Comfort AdjustmentsO M F O R T a D J U S T M E N T S To change the seat heightManual Recline Seatback Adjustment Seat Position AdjustmentSeatback Angle Adjustment Armrest Width AdjustmentArmrestAngle Adjustment Armrest Height AdjustmentFoot Platform Height Adjustment Foot Platform Depth AdjustmentElevating Leg Rests Foot Platform Angle AdjustmentSwing-away Footrests Anti-Tip Wheels To adjust the anti-tip wheelsPower Elevating Seat Actuator Power Elevating Seat OptionTo use the swivel feature Power Elevating Seat OperationTo operate the power elevating seat Charging the Batteries B a T T E R I E S a N D C H a R G I N GBatteries and Charging To charge the batteries using the optional onboard charger To charge the batteries using the off-board chargerBattery Break-in To break in new batteries for maximum efficiencyFrequently Asked Questions FAQs How can I ensure maximum battery life? Why do my new batteries seem weak?How should I store my power chair and its batteries? What type of batteries should I use?VSI Electronic Controller I . O P E R a T I O NVSI consists JoystickOn/Off Key Battery Condition MeterRed lights only lit or slow flash Charge batteries as soon Speed/Profile KeysController Connector Actuator ConnectorCharger Inhibit Connector Actuator Keys and Actuator Lights For Optional EquipmentThermal Rollback VSI Error CodesRemote Plus Master Remote Remote Plus ControllerSpeed Setting Indicator Mode KeyPower Accessory Indicator Right/Left Turn Indicator KeysTo select a speed setting Speed SettingsPower Accessories Power ModuleRemote Plus Trouble Codes Sleep ModeActuator Lighting Module Not Shown Microdrive Controller consists Microdrive ControllerActuator Indicator Profile and Speed IndicatorDisplay Pad Joystick Interface ModuleSpeed Adjustment To select a profile settingError Codes Drive Profile SelectionFlashing Lights Diagnosis Solution Should your power chair come in contact with water Care and MaintenanceTemperature I I . C a R E a N D M a I N T E N a N C EWeekly Checks Daily ChecksTo check the brakes Monthly ChecksCleaning Instructions Disposal of Your Power ChairWheel Replacement StorageBattery Wiring Diagram Label Battery ReplacementTo replace the batteries When to See Your Quantum Rehab Specialist for ServiceCorrective Maintenance W a R R a N T Y Warranty Exclusions Reconditioned Units WarrantyService Checks and Warranty Service Exclusions also include components with damage caused byQuality Control Quantum