Pride Mobility 1121 owner manual Weight Limitations, Tire Inflation, Incline Information

Page 7

I I . S A F E T Y

Weight Limitations

Your power chair is rated for a maximum weight capacity. Please refer to the specifications table for this limit.

WARNING! Exceeding the weight capacity voids your warranty and may result in personal injury and/or damage to your power chair. Pride will not be held responsible for injuries and/or property damage resulting from failure to observe weight limitations.

WARNING! Do not carry passengers on your power chair. Carrying passengers on your power chair may result in personal injury and/or property damage.

Tire Inflation

If your power chair is equipped with pneumatic tires, you should check or have the air pressure checked regularly. Proper inflation pressures will prolong the life of your tires and help ensure the smooth operation of your power chair.

WARNING! It is important that 35 psi (2.4 bar) tire pressure be maintained in pneumatic tires at all times. Do not underinflate or overinflate your tires. Low pressure may result in loss of control, and overinflated tires may burst. Failure to maintain 35 psi (2.4 bar) tire pressure in pneumatic tires at all times may result in tire and/or wheel failure, causing serious personal injury and/or damage to your power chair.

WARNING! Inflate your power chair drive tires from a regulated air source with an available pressure gauge. Inflating your tires from an unregulated air source could overinflate them, resulting in a burst tire and/or personal injury.

Incline Information

More and more buildings have ramps with specified degrees of inclination, designed for easy and safe access. Some ramps may have turning switchbacks (180-degree turns) that require you to have good cornering skills on your power chair.

!Proceed with extreme caution as you approach the downgrade of a ramp or other incline.

!Take wide swings with your power chair’s front wheels around any tight corners. If you do that, the power chair’s rear wheels will follow a wide arc, not cut the corner short, and not bump into or get hung up on any railing corners.

!When driving down a ramp, keep the power chair’s speed adjustment set to the slowest speed setting to ensure a safely controlled descent. See VII. “Operation.”

!Avoid sudden stops and starts.

When climbing an incline, try to keep your power chair moving. If you must stop, start up again slowly and then accelerate cautiously. When driving down an incline, set your power chair to the slowest setting and drive in the forward direction only. If your power chair starts to move down the incline faster than you anticipated or desired, allow it to come to a complete stop by releasing the joystick, then push the joystick forward slightly to ensure a safely controlled descent.

WARNING! When climbing an incline, do not zigzag or drive at an angle up the face of the incline. Drive your power chair straight up the incline. This greatly reduces the possibility of a tip or a fall. Always exercise extreme caution when negotiating an incline.

WARNING! You should not travel up or down a potentially hazardous incline (i.e., areas covered with snow, ice, cut grass, or wet leaves).

WARNING! When on any sort of an incline or decline, never place the power chair in freewheel mode while seated on it or standing next to it. Doing so may result in personal injury and/or damage to your power chair.

WARNING! Never travel down an incline backward. This may result in personal injury.

Quantum1121

www.quantumrehab.com

7

Image 7
Contents Page F E T Y G U I D E L I N E S III N T E N T SInformation Exchange SafetyN T R O D U C T I O N PURCHASER’S AgreementMy Quantum Rehab Specialist Pride Owners ClubS a F E T Y Pre-Ride Safety CheckModifications Tire Inflation Weight LimitationsIncline Information Cornering Information Braking InformationOutdoor Driving Surfaces Stationary Obstacles Steps, Curbs, etc Freewheel ModePublic Streets and Roadways Stairs and Escalators Lift/Elevation Products TransfersDoors ElevatorsReaching and Bending Inclement Weather PrecautionsMotor Vehicle Transport Positioning BeltsAlcohol BatteriesElectromagnetic and Radio Frequency Interference EMI/RFI Quantum I . Y O U R P O W E R C H a I RSpecifications Quantum 1121 Power Base Active-Trac Suspension Electronics TrayTo operate the dual manual freewheel levers Manual Freewheel LeverSeat Installation Initial AssemblyA S S E M B L Y To install the seat To change the seat height Comfort AdjustmentsSeat Height and Seat Angle Adjustment O M F O R T a D J U S T M E N T SArmrest Width Adjustment Seat Position AdjustmentManual Recline Seatback Adjustment Seatback Angle AdjustmentFoot Platform Depth Adjustment Armrest Height AdjustmentArmrestAngle Adjustment Foot Platform Height AdjustmentSwing-away Footrests Foot Platform Angle AdjustmentElevating Leg Rests Anti-Tip Wheels To adjust the anti-tip wheelsPower Elevating Seat Actuator Power Elevating Seat OptionTo operate the power elevating seat Power Elevating Seat OperationTo use the swivel feature Batteries and Charging B a T T E R I E S a N D C H a R G I N GCharging the Batteries To break in new batteries for maximum efficiency To charge the batteries using the off-board chargerTo charge the batteries using the optional onboard charger Battery Break-inFrequently Asked Questions FAQs What type of batteries should I use? Why do my new batteries seem weak?How can I ensure maximum battery life? How should I store my power chair and its batteries?Joystick I . O P E R a T I O NVSI Electronic Controller VSI consistsSpeed/Profile Keys Battery Condition MeterOn/Off Key Red lights only lit or slow flash Charge batteries as soonActuator Keys and Actuator Lights For Optional Equipment Actuator ConnectorController Connector Charger Inhibit ConnectorThermal Rollback VSI Error CodesRemote Plus Master Remote Remote Plus ControllerRight/Left Turn Indicator Keys Mode KeySpeed Setting Indicator Power Accessory IndicatorPower Module Speed SettingsTo select a speed setting Power AccessoriesActuator Lighting Module Not Shown Sleep ModeRemote Plus Trouble Codes Microdrive Controller consists Microdrive ControllerJoystick Interface Module Profile and Speed IndicatorActuator Indicator Display PadDrive Profile Selection To select a profile settingSpeed Adjustment Error CodesFlashing Lights Diagnosis Solution I I . C a R E a N D M a I N T E N a N C E Care and MaintenanceShould your power chair come in contact with water TemperatureMonthly Checks Daily ChecksWeekly Checks To check the brakesStorage Disposal of Your Power ChairCleaning Instructions Wheel ReplacementBattery Wiring Diagram Label Battery ReplacementCorrective Maintenance When to See Your Quantum Rehab Specialist for ServiceTo replace the batteries W a R R a N T Y Exclusions also include components with damage caused by Reconditioned Units WarrantyWarranty Exclusions Service Checks and Warranty ServiceQuality Control Quantum