Seat Controls

Avenger Owner’s Manual

Revised 06/04/08

OPERATION

Armrest Height Adjustments can be made by removing the 2 screws on the back of the armrest and raising to a comfortable position and resetting the screws. The armrest can be raised 3” and by replacing only 1 screw. You can raise the armrest and replace both screws. You will require a 6mm allen wrench for this task.

Armrest Width Adjustment

To adjust the armrest width:

1.Loosen the (2) 6mm adjustment screws at the rear of each arm. Slide each arm to the desired width and tighten the screws.

Seat Height Adjustment (Picture Not Shown)

To adjust the seat height: Lift up on seat rotate lever and turn seat either left or right, lift seat straight up. Holding rotate lever in the up position while lifting seat may make this task easier. Remove 17mm machine screw and place seat post at the desired height and re-insert screw.

Seat Rotation Lever

The seat can be rotated through 360° and locked at any 90° position.

1.Pull up on the seat rotate lever and rotate the seat to the desired position.

2.Release the handle to lock the seat at any 90° position.

WARNING: DO NOT ATTEMPT TO DRIVE YOUR AVENGER

IN ANY SEAT POSITION OTHER THAN FULLY FORWARD.

Flip-Up Armrests

Pull up on the end of either armrest to flip it up for easy transfer on and off your Golden Avenger™.

Seating

The Golden Avenger™ seat is available only in gray vinyl.