Summit HP-1L, HP-1S user manual Wrong connection can make the power wheelchair defective

Page 10

ASSEMBLY & DISASSEMBLY

C. Installing the controller

Your power wheelchair comes standard with a swing-away joystick controller. To install the controller, simply fasten it to the controller supporting bar with the two (2) black screws provided (Fig. 6).

D. Connecting the main cables

Plug the three main cables (connected to left, right motor and battery) underneath the seat near the crossbar to the connectors on the other end of the controller. Cables should be connected according to the indicated labels only, i.e. left to L (motor), right to R (motor), and middle cable to the battery cable only.

ZWarning:

Wrong connection can make the power wheelchair defective.

E.Installing the anti-tippers

Remove the pin on the anti-tipper. Insert the anti-tipper, one on each side, at the rear bottom of the frame. Snap the pins to fasten the anti-tippers (Fig. 8).

F.Installing the footrests and strap

Locate the pins for the footrests on the frame. Put the footrest, one at a time, to the wheelchair. Slide the footrest strap accordingly.

Controller

Supporting

Bar

Fig. 6

Fig. 7

Pin

Fig. 8

Page 8

Image 10
Contents USER’S Manual HP-1L HP-1STable of Contents Introduction Components Safety Instructions Operation of ChairGeneral Safety Instructions Environmental Conditions Assembly & Disassembly AssemblyWrong connection can make the power wheelchair defective Disassembly Assembly & Disassembly Adjustments for Seating Comfort ButtonSpeed to your desired setting. Turning the speed OperationDiagnosis Solution ZWarning Reset Button Batteries & Charger BatteryCharger Charging Instructions Daily Checks Maintenance & RepairWeekly Checks SEMI-ANNUAL Checks Periodical ChecksMaintenance & Repair Specifications Limited Warranty Five-Year Limited Warranty Power chair frameAuthorized Summit DME dealer