Assembly & Disassembly

ASSEMBLY

A.Opening the wheelchair

Standing at one side of the wheelchair, tilt it to one side, and push down firmly on the seat rails. The seat should be locked into the receivers on the wheelchair side frame when the chair is fully opened.

B.Installing the batteries (not provided)

Note: We recommend using a battery with 12 volt 34AH (for example, U-1) for better performance. Each battery weighs more than 23 lbs. as an average. Please seek help if you cannot lift them by yourself.

Put the batteries into the battery boxes. Using the screws, washers, and nuts provided from the battery supplier, connect the red line to the Positive (+) terminal of a battery while connecting the black line to the Negative ( ) terminal of the same battery (Fig. 2). Close the box properly and carry it with the strap. Apply the same connecting method to both batteries.

Fig. 2

Battery Bar

Fig. 3

Fold down the battery bars on each side of the frame so that you can slide the battery boxes underneath the seat (Fig. 3). The battery box with the reset button and two outlet connectors should be put underneath the power chair first. The outlet connectors of the battery boxes should be put on the same side for connection.

Connect the two battery connectors (Fig. 4). Put the battery supporting bar at the back of the battery box. Screw on the battery knobs to tightly fasten the bar (Fig. 5).

Battery

Connector

	Battery Knobs
Fig. 4	Fig. 5

Page 7