MAINTENANCE & REPAIR
SEMI-ANNUAL CHECKS
1.Check the motor brushes. We recommend that your authorized dealer inspect the brushes every six months, or sooner if your power wheelchair is not operating smoothly. If inspection determines excessive wear on the brushes, they must be replaced or motor damage will result.
ZWarning! Failure to maintain the brushes could void the power wheelchair’s warranty.
To inspect or replace the motor brushes:
1.Unscrew the motor brush caps (Fig. 18).
2.Remove the brushes.
3.Inspect the brushes for wear (Fig. 19).
4.Replace the brushes if necessary.
2.Inspect the state of the battery terminals ever y six months. Make sure that they are not corroded and the connections are tight. Periodically apply a thin film of petroleum jelly on the surface of terminals to Guard against corrosion.
PERIODICAL CHECKS
Motor Brush Caps
Fig. 18
Worn Motor Brush
New Motor Brush
Fig. 19
1.Make sure to keep the controller clean while protecting it from rain or water. Never hose off your power wheelchair or place it in direct contact with water.
2.Keep wheels free from lint, hair, sand and carpet fibers.
3.Visually inspect the tire tread. If less than 1/32", please have your tires replaced by your local dealer.
4.All upholstery can be washed with warm water and mild soap. Occasionally check the seat and back for sagging, cuts and tears. Replace if necessary. Do not store your chair in damp conditions as this will lead to mildew and rapid deterioration of the upholstery parts.
5.All moving mechanisms will benefit from simple lubrication and inspection. Lubricate using petroleum jelly or light oil. Do not use too much oil, otherwise small drips could stain and damage carpets and furnishings etc. Always perform a general inspection of the tightness of all nuts and bolts.
Page 19