HP Enterprise CP5525 manual 108Install the main drive assembly 7 Removal and replacement

6.With the drive assembly correctly installed, verify the following:

●Open and close the front door. The OPC drum drive gears (callout 1; two shown, four total) must move in and out when viewed from inside the product.

●Open and close the right door. The ITB drive gear (callout 2) must move in and out when viewed from inside the product.

Figure 2-107Install the main drive assembly (6 of 8)

2

1

7.Install the remaining five mounting screws, tighten all six screws (callout 1), and then remove the orange spacers and spacer shipping tape.

Figure 2-108Install the main drive assembly (7 of 8)

1

170 Chapter 2 Removal and replacement ENWW