HP Enterprise CP5525 manual 118Remove the fuser gear assembly 3

2.Remove one screw (callout 1), release four tabs (callout 2), and then separate the first transfer high-voltage power supply (callout 3) from the product.

CAUTION: The PCA is still connected to the product.

Reinstallation tip When you reinstall the power supply PCA, look through the holes on the PCA (callout 5) and make sure that the contact springs are correctly positioned against the back side of the PCA.

Figure 2-117Remove the fuser gear assembly (2 of 9)

2

5

4 3

1

3. Disconnect one connector (callout 1) and then remove the first transfer high-voltage power supply (callout 2).

Figure 2-118Remove the fuser gear assembly (3 of 9)

1

2

ENWW Removal and replacement procedures 177