HP Enterprise CP5525 manual Enww

2.Replacement fuser drive assembly: Fasten the replacement fuser gear assembly to the product with four screws. Install the screws in the order shown below (callouts 1 to 4).

Original fuser drive assembly: Install, but do not fully tighten four screws (callouts 1 to 4). Carefully push the drive assembly to the left (toward the right-door side of the product) until it slightly shifts forward. Apply steady pressure to hold the assembly in place, and then tighten the screws.

Figure 2-114Install a replacement fuser drive assembly (2 of 3)

2

1

3

4

3.Replacement fuser drive assembly: Release two tabs in the order shown below (callouts 1 and 2). and then remove the spacer (callout 3).

Original fuser drive assembly: Installation complete—this step is not required. Figure 2-115Install a replacement fuser drive assembly (3 of 3)

2

1

3

ENWW Removal and replacement procedures 175