Table 3-61MP modes under the Adjust Paper Types sub menu (continued)

HUMIDITY MODE

With glossy film, set to High when the product is in a high-

 

humidity environment and print-quality defects occur on HP

 

Tough Paper or Opaque film.

 

With transparencies, set to High when the product is in a

 

high-humidity environment and print-quality defects occur on

 

color transparencies on the first page of a print job.

 

With all other paper types, set to High when the product is in

 

a high-humidity environment and light density occurs on the

 

first page of a print job.

 

 

FUSER TEMP MODE

If you are seeing a faint image of the page repeated at the

 

bottom of the page or on the following page, first make sure

 

the Paper Type and Print Mode settings are correct for the

 

type of paper you are using. If you continue to see ghost

 

images on your print jobs, set the Fuser Temp feature to one of

 

the Alternate settings . Try the ALTERNATE 1 setting first and

 

see if it solves the problem. If you continue to see the problem,

 

try ALTERNATE 2 and then ALTERNATE 3. Using the

 

ALTERNATE 2 and ALTERNATE 3 settings might cause an

 

extra delay between jobs.

 

 

PAPER CURL MODE

Use in high-humidity and high-temperature environments. The

 

REDUCED setting decreases fuser temperature and increases

 

the interpage gap.

 

 

Table 3-62MP modes under the Optimize submenu

NORMAL PAPER

Set to SMOOTH when printing on smooth paper of normal

 

weight.

 

 

HEAVY PAPER

Set to SMOOTH when printing on smooth, heavy media

 

types.

 

 

LIGHT MEDIA

Set to SMOOTH when printing on smooth, light media types.

 

 

ENVELOPE CONTROL

Set to REDUCED TEMP if envelopes are sticking due to

 

moisture in the envelop adhesive.

 

 

ENVIRONMENT

Set to LOW TEMP if the product is operating in a low-

 

temperature environment and you are having problems with

 

print quality such as blisters in the printed image.

 

 

LINE VOLTAGE

Set to LOW VOLTAGE if the product is operating in a low-

 

voltage environment and you are having problems with print

 

quality such as blisters in the printed image.

 

 

TRAY1

Set to ALTERNATE if you are seeing marks on the back side

 

of the paper when printing from Tray 1. This sets the product

 

to initiate a clean sequence every time a job finishes when the

 

product is set for Any Size and Any Type for Tray 1.

 

 

BACKGROUND

Set to ALTERNATIVE 1 when a background occurs all over

 

the page. Set to ALTERNATIVE 2 when thin vertical lines

 

appear on the page. Set to ALTERNATIVE 3 when the other

 

alternatives do not correct the problem.

 

 

522 Chapter 3 Solve problems

ENWW

Page 546
Image 546
HP Enterprise CP5525 manual 62MP modes under the Optimize submenu, Humidity Mode