HP Enterprise CP5525 manual First transfer high-voltage power supply

First transfer high-voltage power supply

Before proceeding, remove the following components:

●Toner collection unit. See Toner-collection unit on page 91.

●Right-front cover and control-panel assembly. See Right-front cover and control-panel assembly on page 113.

●Left cover. See Left cover on page 115.

●Rear cover. See Rear cover on page 116.

●Toner collection unit access door. See Toner collection unit access door on page 117.

●Right-rear cover. See Right-rear cover on page 119.

●Top cover. See Top cover on page 121.

●Toner cover. See the first and second steps of Residual toner full sensor on page 152.

Remove the first transfer high-voltage power supply

CAUTION: ESD-sensitive part.

1.Remove one screw (callout 1), release three tabs (callout 2), and then slide the power supply off the alignment post (callout 3).

Figure 2-164Remove the first transfer high-voltage power supply (1 of 2)

2

3

1

214 Chapter 2 Removal and replacement ENWW