HP Enterprise CP5525 manual 23Component tests 1

Each component test can be performed once or repeatedly. If you select the Repeat option (at the end of the menu), the test cycles the component on and off. This process continues for two minutes, and then the test terminates.

NOTE: The front or side door interlocks must be defeated to run the component tests. Some tests may require that the ITB and print cartridges be removed. The control panel display prompts you to remove some or all cartridges during certain tests.

1.Press the Home button.

2.Open the following menus:

●Administration

●Troubleshooting

●Diagnostic Tests

3.Press the Down arrow to highlight the Component Test item, and then press the OK button.

4.Select the component test options for the test you want to run.

Table 3-23Component tests (1 of 2)

Component test	Component tested	Comments
Transfer Motors	M1 (ITB motor)	Drives the ITB motor and drum
	M2 (drum motor)	motor together at a specified
		speed for 5 seconds.
Belt Only	M1 (ITB motor)	Drives ITB drive motor at a
		specified speed for 5 seconds.
Developer Motors	M1 (ITB motor)	Drives the ITB motor at a
	M3 (developer motor)	specified speed for 5 seconds.
		Drives the developer motor at
		a specified speed for 5
		seconds (drives 3 times).
Cartridge Motors	M1 (ITB motor)	Drives the ITB motor at a
	M2 (drum motor)	specified speed for 5 seconds.
		Drives the drum motor at a
		specified speed for 5 seconds
		(drives 3 times).
Fuser Motor	M4	Drives the fuser motor at a
		specified speed for 5 seconds.
Alienation Motor (cartridge)	M6 (developer alienation motor)	Drives the developer
		disengagement motor and
		engages or disengages the
		developer (drives the motor
		four times). If the home
		position of the developer is not
		commanded within 5 seconds,
		the product brings the
		developer to its home position.

ENWW Tools for troubleshooting 315