HP Enterprise CP5525 manual Clean the product, Clean the paper path, Set up an auto cleaning

Clean the product

Over time, particles of toner and paper accumulate inside the product. This can cause print-quality problems during printing. Cleaning the product eliminates or reduces these problems.

Clean the paper path and print-cartridge areas every time that you change the print cartridge or whenever print-quality problems occur. As much as possible, keep the product free from dust and debris.

To clean the product exterior, use a soft, water-moistened cloth.

Clean the paper path

NOTE: If you are processing a cleaning page to clean the fuser, repeat the process 1 to 6 times until the paper comes out clean.

Process a cleaning page

1.Press the Home button .

2.Open the following menus:

●Device Maintenance

●Calibration/Cleaning

3.Press the Down arrow to highlight the Print Cleaning Page item, and then press the OK button.

4.The product prints a cleaning page, and then returns to the main menu. Discard the printed page.

Set up an auto cleaning page

Use the procedure in this section to set up an automatic cleaning page.

1.Press the Home button .

2.Open the following menus:

●Device Maintenance

●Calibration/Cleaning

3.Press the Down arrow to highlight the Auto Cleaning item, and then select the Enabled item. Press the OK button.

4.Press the Down arrow to highlight the Cleaning Interval item, and then use the arrow buttons to select an interval. Press the OK button.

TIP: HP recommends processing a cleaning page after every 5000 printed pages.

5.Press the Down arrow to highlight the Auto Cleaning Size item, and then use the arrow buttons to select the cleaning page size. Press the OK button.

ENWW Clean the product 531