HP Enterprise CP5525 manual Secondary transfer roller

Secondary transfer roller

CAUTION: Do not touch the spongy roller surface unless you are replacing the roller. Skin oils on the roller can cause image quality problems.

NOTE: If the secondary transfer roller is replaced, HP recommends that the ITB be replaced also. If both components are replaced at the same time, you must use the control-panel menus to reset the Transfer Kit menu item. See Reset the New Transfer Kit setting at the control panel on page 104.

1.Open the right-door assembly.

2.Grasp one of the blue round features (callout 1) on either end of the transfer roller, and then lift the transfer roller (callout 2) off of the product.

Figure 2-17Remove the transfer roller

1

2

TIP: Place the new roller assembly in place with the roller gear (callout 1) on the right side, and then press down to ensure that the roller shaft snaps securely in the roller clasps.

1

ENWW Removal and replacement procedures 101