2.With the right door closed, position the drive assembly near the product, and then rotate it up and onto the chassis.

NOTE: Make sure that the right-door link arm shaft (callout 1) aligns with and is positioned in the hole (callout 2) on the arm on the drive assembly, and that the pins on the assembly (callout 3) are positioned in the holes in the link arms on the chassis (callout 4).

Figure 2-103Install the main drive assembly (2 of 8)

4

1

2

3

3.Install one screw (callout 1).

NOTE: Do not fully tighten this screw.

Figure 2-104Install the main drive assembly (3 of 8)

1

168 Chapter 2 Removal and replacement

ENWW

Page 192
Image 192
HP Enterprise CP5525 manual 104Install the main drive assembly 3 Removal and replacement