4.From the top of the product, look at each shutter arm. Make sure that they are in the closed position (callout 1). If they are in the open position (callout 2), carefully push on the shutters to close them.

Figure 2-105Install the main drive assembly (4 of 8)

1

2

5.Make sure that the six sheet-metal screw tabs (callout 1) on the drive assembly are flat against the product chassis.

NOTE: If the tabs are not flat against the chassis, the developer-disengagement drive gears and cams—on the back side of the drive assembly—are not properly aligned with, and seated in, the corresponding holes on the product. Remove the drive assembly, realign it, and then reinstall it.

See Figure 2-103 Install the main drive assembly (2 of 8) on page 168.

Figure 2-106Install the main drive assembly (5 of 8)

1

ENWW

Removal and replacement procedures 169

Page 193
Image 193
HP Enterprise CP5525 manual See -103 Install the main drive assembly 2 of 8 on