HP Enterprise CP5525 manual 162Remove the low-voltage power supply 3

2.Slightly lift up on the low-voltage power supply (callout 1), slide it slightly forward, disconnect eight connectors (callout 2), and then release the cables from the front cable clamp.

WARNING! Do not use the power supply electric element (callout 3) as a handle to pull out the power supply.

TIP: One of the connectors (callout 2) is located far back inside the product.

Figure 2-161Remove the low-voltage power supply (2 of 3)

2

3

1

3.Release the cables (callout 2) from the rear cable clamp (callout 1), disconnect one rear connector (callout 3), and then remove the low-voltage power supply unit (callout 4).

Figure 2-162Remove the low-voltage power supply (3 of 3)

32

1

4

ENWW Removal and replacement procedures 211