HP Enterprise CP5525 manual Residual-toner-feed assembly, Remove the residual-toner-feed assembly

Residual-toner-feed assembly

Before proceeding, remove the following components:

●Intermediate transfer belt (ITB). See Intermediate transfer belt (ITB) on page 102.

●Left cover. See Left cover on page 115.

●Rear cover. See Rear cover on page 116.

●Toner collection unit access door. See Toner collection unit access door on page 117.

●Right-rear cover. See Right-rear cover on page 119.

●Top cover. See Top cover on page 121.

●Toner cover. See the first step of Residual toner full sensor on page 152.

Remove the residual-toner-feed assembly

1.Release one tab (callout 1) by pulling the tab up. If necessary, use a small, flat-blade screwdriver to pull the tab up. Remove the shutter (callout 2), and then pull the spring (callout 3) off the assembly.

NOTE: There might be a piece of transparent tape over the tab (callout 1). Remove the tape to release the tab.

Figure 2-137Remove the residual-toner-feed assembly (1 of 2)

31

2

190 Chapter 2 Removal and replacement ENWW