Panasonic CW-XC104HK, CW-XC104HU manual Cabinet Installation, Very slight tilt about 1/212.7mm

Features and Installation

Cabinet Installation
1. Open the window. Mark a line on
center of the window sill(or desired air
conditioner location).
Carefully place the cabinet on the		Upper Guide
window sill and align the center mark
				Window sill
on the bottom front with the center
				Front Angle	Fig. 1
line marked in the window sill.
(See Fig.1)		Window Sash		Upper guide
2. Pull the bottom window sash down
behind the upper guide until it meets.		Foam-pe 11
(See Fig.2)		Cabinet
NOTE:		Frame Curtain 1
			Foam-pe 8		Fig. 2
• Do not pull the window sash down so
tightly that the movement of Frame
Curtain is restricted.		INDOOR		OUTDOOR
3. Loosely assemble the sill support				Sill Support 2
using the parts in Fig. 3.		Bolt 3		Nut 4	Fig. 3
4. Select the position that will place the				Screw (Type A) 5
sill support near the outer most point
on sill (See Fig. 4)					About 1/2" (12.7mm)
5. Attach the sill support to the cabinet				Cabinet
track hole in relation to the selected		INDOOR		OUTDOOR Fig. 4
position using 2 Type A screws in
each support (See Fig. 4).
very slight tilt (about 1/2"(12.7mm))		Screw (Type B)		6	"(12.7mm)2
6. The cabinet should be installed with a
downward toward the outside (See					1/
					About
Fig. 5).
Adjust the bolt and the nut of sill				Sill support 2
support for balancing the cabinet.
7. Attach the cabinet to the window sill				Sash track
by driving the screws	(Type B)
through the front angle into window
sill.
8. Pull each Frame curtain fully to each				Front Angle
window sash track, and repeat step 2.			Screw (Type B) 6		Fig. 5
		Sill support	2
		12