Pride Mobility Jet 10 owner manual Armrest Angle, Armrest Height Optional, Joystick Extension

V I . C O M F O R T A D J U S T M E N T S

ARMREST ANGLE

You can adjust the armrest angle to fit your specific needs. See figure 14.

To change the armrest angle:

1.Lift the armrest straight up so that it is perpendicular to the floor.

2.Use a 1/2-in. wrench to loosen the jam nut. See figure 14.

3.Use a 1/2-in. wrench to loosen the adjusting screw.

4.Turn the screw clockwise to lower the front of the armrest, or turn the screw counterclockwise to raise the front of the armrest.

5.Lock the adjusting screw into place by tightening the jam nut.

ARMREST HEIGHT (OPTIONAL)

Your Jet 10 may be equipped with height-adjustable arm- rests.

To change the armrest height:

1.Locate the two setscrews under the rear of the arm- rests. See figure 13.

2.Use a 5/32-in. hex key to loosen the screws, then slide the armrests in or out for the desired width.

3.Tighten the setscrews.

JOYSTICK EXTENSION

The joystick control can easily slide out away from the armrest, or in toward the armrest. See figure 15.

To extend the joystick:

1.Use a 5 mm hex key to loosen the setscrew.

2.Slide the joystick mounting bracket into or out of the armrest to the desired position.

3.Tighten the setscrew by turning the hex key clockwise.

JAM NUT LOCKS

ADJUSTING

SCREW IN PLACE.

TURN THIS SCREW TO

CHANGEARMREST

ANGLE.

Figure 14. Armrest Angle Adjustment

LOOSEN

THIS

SETSCREW

TOADJUST

JOYSTICK

Figure 15. Joystick Extension

Jet 10/Rev H/Feb03 www.pridemobility.com 23