I V . A S S E M B L Y
Seat Installation
It may be necessary to install the seat either prior to initial operation or after transporting your power chair.
WARNING! Do not pick up the seat frame by the armrests. They are free to pivot, and you may lose control of the seat if they do so.
To install the seat:
1.Set the seat on the seat tower. See figure 10.
2.Push the seat down until the latch engages.
3.Install the controller and route the cable to the rear of the power base. See figure 11.
4.Plug the controller connector into the power base. See figure 6.
5.Secure the controller cable to the armrest receiver with wire ties.
SEAT |
TOWER |
Figure 10. Seat Installation
Figure 11. Cable Routing
22 | www.pridemobility.com | Jazzy Select 14 Series |