Pride Mobility INFMANU3890 manual B a T T E R I E S a N D C H a R G I N G, Batteries and Charging

Page 24

I V . B A T T E R I E S A N D C H A R G I N G

BATTERIES AND CHARGING

Your scooter requires two long-lasting, 12-volt, deep-cycle batteries that are sealed and maintenance free. They are recharged by an off-board charging system.

Charge your scooter’s batteries prior to using it for the first time.

Keep the batteries fully charged to keep your scooter running smoothly.

READING YOUR BATTERY VOLTAGE

The battery condition meter on the tiller console indicates the approxi- mate strength of your batteries using a color code. From right to left, green indicates fully charged batteries, yellow indicates a draining charge, and red indicates that an immediate recharge is necessary. See figure 10. To ensure the highest accuracy, the battery condition meter should be checked while operating your scooter at full speed on a dry, level surface.

CHARGING YOUR BATTERIES

PROHIBITED! Removal of grounding prong

Figure 10. Battery Condition Meter

can create electrical hazard. If necessary,

 

properly install an approved 3-pronged

 

adapter to an electrical outlet having 2-

 

pronged plug access.

 

PROHIBITED! Never use an extension cord to plug in your battery charger. Plug the charger directly into a properly wired standard electrical outlet.

PROHIBITED! Do not allow unsupervised children to play near the scooter while the batteries are charging. Pride recommends that you do not charge the batteries while the scooter is occupied.

MANDATORY! Read the battery charging instructions in this manual and in the manual supplied with the battery charger before charging the batteries.

WARNING! Explosive gases may be generated while charging the batter- ies. Keep the scooter and battery charger away from sources of ignition such as flames or sparks and provide adequate ventilation when charging the batteries.

WARNING! You must recharge your scooter’s batteries with the supplied off- board charger. Do not use an automotive-type battery charger.

WARNING! Inspect the battery charger, wiring, and connectors for damage before each use. Contact your authorized Pride Provider if damage is found.

WARNING! Do not attempt to open the battery charger case. If the battery charger does not appear to be working correctly, contact your authorized Pride Provider.

WARNING! If the battery charger is equipped with cooling slots, then do not attempt to insert objects through these slots.

WARNING! If your battery charger has not been tested and approved for out- door use, then do not expose it to adverse or extreme weather conditions. If the battery charger is exposed to adverse or extreme weather conditions, then it must be allowed to adjust to the difference in environmental conditions before use indoors. Refer to the manual supplied with the battery charger for more information.

24

www.pridemobility.com

Pursuit

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Pursuit F E T Y G U I D E L I N E S N T E N T S Safety N T R O D U C T I O NPURCHASER’S Agreement Shipping and DeliveryProduct Safety Symbols S a F E T YS a F E T Y S a F E T Y S a F E T Y Removable Parts PRE-RIDE Safety Check GeneralModifications Weight Limitations Tire InflationIncline Information S a F E T Y Cornering Information Braking InformationOutdoor Driving Surfaces Correct Curb ApproachInclement Weather Precautions Freewheel ModeStairs and Escalators DoorsBattery Disposal and Recycling ElevatorsLift SYSTEMS/ELEVATION Products BatteriesMotor Vehicle Transport Getting Onto and OFF of Your ScooterReaching and Bending Positioning Belts Prescription DRUGS/PHYSICAL LimitationsALCOHOL/SMOKING Electromagnetic and Radio Frequency Interference EMI/RFI Speed Adjustment Dial Key SwitchBattery Condition Meter I . Y O U R S C O O T E RTurn Signal Buttons Lights SwitchHazard Lights Switch Status LEDHi-Low Switch Off-board Charger PortElectrical System Fuses Motor/Transaxle Assembly Rear SectionBatteries Anti-Tip WheelsMain Circuit Breaker Reset Button Securing the ScooterReading Your Battery Voltage B a T T E R I E S a N D C H a R G I N GBatteries and Charging Charging Your BatteriesFrequently Asked Questions Follow these easy steps to charge the batteriesHow does the charger work? Can I use a different charger?How can I ensure maximum battery life? What type and size of battery should I use?How often must I charge the batteries? How can I get maximum range or distance per charge?How do I change a battery in my scooter? Battery Removal/InstallationWhy do my new batteries seem weak? What about public transportation?PRE-RIDE Adjustments and Checks P E R a T I O NBefore Getting Onto Your Scooter Getting Onto Your ScooterPower Down Timer Feature Getting OFF of Your ScooterTiller Angle Adjustment Seatback AdjustmentC O M F O R T a D J U S T M E N T S Mirror PositionSeat Rotation Adjustment FRONT-TO-BACK Seat AdjustmentSeat Height Adjustment Disassembly I . D I S a S S E M B L Y a N D a S S E M B L YAssembly Frame SeparationSee figure I I . B a S I C Troubleshooting Diagnostic Fault CodesWhat if the main circuit breaker repeatedly trips? Wheel Replacement C a R E a N D M a I N T E N a N C ETire Pressure Cleaning and Disinfection Battery Terminal ConnectionsWiring Harnesses Exterior SurfacesFuse Replacement Nylon Lock NUT ReplacementEvent a fuse should cease to work Storing Your ScooterP E N D I X I Specification S Dimensions T E S Page INFMANU3890
Top Page Image Contents