Pride Mobility INFMANU3890 manual Elevators, Lift SYSTEMS/ELEVATION Products, Batteries

Page 15

I I . S A F E T Y

ELEVATORS

Modern elevators have a door edge safety mechanism that, when pushed, reopens the door(s).

If you are in the doorway of an elevator when the door(s) begin to close, push on the rubber door edge or allow the rubber door edge to contact the scooter and the door will reopen.

Use care that pocketbooks, packages, or scooter accessories do not become caught in elevator doors.

NOTE: If your scooter’s turning radius is greater than 60 in. (152.4 cm) it may be difficult to maneuver in elevators and building entrances. Use caution when attempting to turn or maneuver your scooter in small spaces, and avoid areas that might pose a problem.

LIFT SYSTEMS/ELEVATION PRODUCTS

If you will be transporting your scooter during travel, you may find it necessary to use a vehicle-mounted lift system or elevation product to aid in transportation. Pride recommends that you closely review the warnings, instructions, specifications, and safety information set forth by the manufacturer of the lift/ elevation product before using that product.

WARNING! Not all lift systems/elevation products are rated for use with an occupied mobility device. Pride recommends that you do not remain seated in your scooter when it is being used in connection with any type of lift system/elevation product unless:

That product is rated for occupied use by the manufacturer.

You are able to occupy your mobility device in strict conformity with the warnings, instructions, specifications, and safety guidelines set forth by the manufacturer.

WARNING! Always turn off the power to the scooter when you are being transferred via an elevation product. Failure to do so may result in accidental throttle control lever con- tact, resulting in unintended movement and personal injury or product damage.

BATTERIES

In addition to following the warnings below, be sure to comply with all other battery handling information.

MANDATORY! Battery posts, terminals, and related accessories contain lead and lead compounds. Wear goggles and gloves when handling batteries and wash hands after handling.

WARNING! Scooter batteries are heavy. See specifications table. If you are unable to lift that much weight, be sure to get help. Use proper lifting techniques and avoid lifting beyond your capacity.

WARNING! Always protect the batteries from freezing and never charge a frozen battery. Charging a frozen battery may result in damage to the battery.

WARNING! Connect the battery harnesses in the proper manner. RED (+) cables must be connected to positive (+) battery terminals/posts. BLACK (-) cables must be connected to negative (-) battery terminals/posts. Protective caps should be installed over all battery terminals. REPLACE cables immediately if damaged.

BATTERY DISPOSAL AND RECYCLING

If you encounter a damaged or cracked battery, immediately enclose it in a plastic bag. Contact your local waste disposal agency or your authorized Pride Provider for instructions on disposal and battery recycling, which is our recommended course of action.

PREVENTING UNINTENDED MOVEMENT

WARNING! If you anticipate being seated in a stationary position for an extended period of time, turn off the power. This will prevent unexpected motion from inadvertent throttle control lever contact.

Pursuit

www.pridemobility.com

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Pursuit F E T Y G U I D E L I N E S N T E N T S Shipping and Delivery SafetyN T R O D U C T I O N PURCHASER’S AgreementS a F E T Y Product Safety SymbolsS a F E T Y S a F E T Y S a F E T Y Removable Parts PRE-RIDE Safety Check GeneralModifications Weight Limitations Tire InflationIncline Information S a F E T Y Braking Information Cornering InformationCorrect Curb Approach Outdoor Driving SurfacesDoors Inclement Weather PrecautionsFreewheel Mode Stairs and EscalatorsBatteries Battery Disposal and RecyclingElevators Lift SYSTEMS/ELEVATION ProductsMotor Vehicle Transport Getting Onto and OFF of Your ScooterReaching and Bending Positioning Belts Prescription DRUGS/PHYSICAL LimitationsALCOHOL/SMOKING Electromagnetic and Radio Frequency Interference EMI/RFI I . Y O U R S C O O T E R Speed Adjustment DialKey Switch Battery Condition MeterStatus LED Turn Signal ButtonsLights Switch Hazard Lights SwitchHi-Low Switch Off-board Charger PortElectrical System Fuses Anti-Tip Wheels Motor/Transaxle AssemblyRear Section BatteriesSecuring the Scooter Main Circuit Breaker Reset ButtonCharging Your Batteries Reading Your Battery VoltageB a T T E R I E S a N D C H a R G I N G Batteries and ChargingCan I use a different charger? Frequently Asked QuestionsFollow these easy steps to charge the batteries How does the charger work?How can I get maximum range or distance per charge? How can I ensure maximum battery life?What type and size of battery should I use? How often must I charge the batteries?Battery Removal/Installation How do I change a battery in my scooter?What about public transportation? Why do my new batteries seem weak?Getting Onto Your Scooter PRE-RIDE Adjustments and ChecksP E R a T I O N Before Getting Onto Your ScooterGetting OFF of Your Scooter Power Down Timer FeatureMirror Position Tiller Angle AdjustmentSeatback Adjustment C O M F O R T a D J U S T M E N T SSeat Rotation Adjustment FRONT-TO-BACK Seat AdjustmentSeat Height Adjustment I . D I S a S S E M B L Y a N D a S S E M B L Y DisassemblyAssembly Frame SeparationSee figure Diagnostic Fault Codes I I . B a S I C TroubleshootingWhat if the main circuit breaker repeatedly trips? Wheel Replacement C a R E a N D M a I N T E N a N C ETire Pressure Exterior Surfaces Cleaning and DisinfectionBattery Terminal Connections Wiring HarnessesStoring Your Scooter Fuse ReplacementNylon Lock NUT Replacement Event a fuse should cease to workP E N D I X I Specification S Dimensions T E S Page INFMANU3890
Top Page Image Contents