Pride Mobility Mobility Power Chair manual Power Seat Elevator Option

16 Basic Operation Instructions

POWER SEAT ELEVATOR OPTION

The power seat elevator provides lift of up to 7 in. (18 cm) from the power base using a single post plate and actuator. See figure 9. The maximum weight capacity of the power seat elevator is 300 lbs. (136 kg) and is available on some models. Contact your Quantum Rehab Specialist for specific information. The power seat elevator operates through the power chair controller, toggle switch, or Attendant Control Module.

NOTE: When the seat is elevated, a 1/4-speed drive inhibit is engaged and you are no longer able to tilt the seat. See figure 2.

NOTE: Operation instructions using the joystick 4-way toggles are dis- cussed below. If you are using a different toggle, the Attendant Control Module, or a different operating device, please refer to the appropriate section of this manual or the operation manual supplied with that device and/or your power chair owner’s manual.

To operate the power seat elevator:

1.Push the toggle switch to the left to elevate the seat.

2.Push the toggle switch to the left, release, then push to the left again to lower the seat.

Actuator

Figure 9. The Power Seat Elevator Option on a Synergy TRU-Balance Power Recline

Synergy TRU-Balance Power Recline www.quantumrehab.com