Pride Mobility Mobility Power Chair manual Controller Position, To change the controller position

20 Basic Operation Instructions

CONTROLLER POSITION

You can position the controller for either left-hand or right-hand use. You can also adjust the extension of the controller from the armrest.

WARNING! Do not place the controller cable so that it can be pinched in the seat frame or the power base frame.

To change the controller position:

1.Turn off the power to the controller.

2.Unplug the controller connector from the power base. Refer to the power base owner’s manual.

3.Remove any wire ties securing the controller cable to the armrest.

4.Loosen the mounting screws in the controller mounting block. See figure 13.

5.Move the controller mounting block and controller to the other armrest and tighten the mounting screws.

6.Route the controller cable to the back of the power base and reconnect the controller. See figure 14.

To change the controller extension:

1.Turn off the power to the controller.

2.Loosen the setscrews in the controller mounting block. See figure 13.

3.Slide the controller into or out of the armrest to the desired position.

4.Tighten the setscrews to secure the controller.

Mounting Block

Mounting Screws

Set Screws

Figure 13. Controller Position -	Figure 14. Cable Routing
Mounting Block

Synergy TRU-Balance Power Recline www.quantumrehab.com