V I I I . C O M F O R T A D J U S T M E N T S
SEATBACK ADJUSTMENT
WARNING! Do not operate your scooter with the seatback in a reclined position. WARNING! Always keep your back pressed firmly against the seat back while adjusting it.
To adjust your Legend's reclining seat, perform these steps. See figure 10A.
1.While pulling up on the seatback adjustment lever, lean forward or backward to adjust the seatback.
2.Release the seatback adjustment lever once the seat is in a comfortable riding position.
ARMREST ANGLE ADJUSTMENT
The armrests of your scooter can be adjusted upward or downward. See figure 10B.
νBy turning the adjustment dial, the armrest will either raise or lower.
NOTE: The armrests also pivot upward to make getting on and off of your scooter easier.
ADJUSTMENT
DIAL
Figure 10A. Seatback Adjustment Lever | Figure 10B. Armrest Angle Adjustment |
SEAT HEIGHT ADJUSTMENT
The seat can be repositioned to different heights. See figure 11.
1.Remove the seat and shroud from your Scooter. See IX. “DisassemblyandAssembly.”
2.Loosen the seat height adjustment
3.Loosen the seat post bolt.
4.Raise or lower the upper seat post to the desired seat height.
5.While holding the upper seat post at that height, match up the locating holes in the upper seat post with those of the lower seat post.
6.With one washer on the seat height adjustment bolt insert it through the locating holes of both the upper and lower seat posts. Reinstall the other washer and
SEAT HEIGHT ADJUSTMENT
SEAT POST
UPPER SEAT POST
LOCATING
HOLES
SEAT HEIGHT ADJUSTMENT BOLT
NOTE: Ensure both washers have been reinstalled before fully tightening the
7.Tighten the seat post bolt
8.Reinstall the rear shroud and the seat.
SEAT POST
BOLT
LOWER SEAT POST
Figure 11. Seat Height Adjustment
30 | www.pridemobility.com | Legend |