O U R S C O O T E R, Tiller Console | Pride Mobility Legend 3

I V . S P E C I F I C A T I O N S

Model Numbers	3-wheel:SC3000, 4-wheel:SC3400

Available Colors4	Painted: Champagne (Standard)
Overall Length2	3-wheel: 45.5 in., 4-wheel: 47 in.
Overall Width2	24 in.
Total Weight Without Batteries	3-wheel: 157 lbs., 4-wheel: 166 lbs.
Heaviest Piece When Disassembled	Rear frame: 61 lbs.
Turning Radius2	3-wheel: 41 in., 4-wheel: 58 in.
Speed (max)1	Variable up to 5.75 mph
Range Per Charge1	(With 32 Ah batteries) Up to 25 miles
Ground Clearance2	3.5 in.
Weight Capacity	350 lbs.
Standard Seating	Type: CRS Deluxe Reclining High Back with headrest
	and sliders.
	Dimensions: 18 in. width
	18 in. depth
	20 in. height; with headrest 24 in. – 28 in.
	Material: Gray vinyl or Gray fabric

Standard Seat Weight	45 lbs.
Drive System	Rear-wheel drive, sealed transaxle with a 24-volt DC
	motor

Dual Braking System	Electronic, regenerative, and electromechanical
Wheels	Aluminum alloy mags
Tires	Type: pneumatic; front: 3.5 in. x 10 in., rear: 4 in. x 10 in.
Battery Requirements3	Two 12-volt deep cycle, Size: U-1, 31-36 Ah
Battery Weight	24.5 lbs. each
Battery Charger	Onboard

1Varies with user weight, terrain type, battery amp-hour (Ah raiting), battery charge, battery condition, and tire condition.

2Due to manufacturing tolerances and continual product improvement, this specification can be subject to a variance of (+ or – ) 3 %.

3AGM or Gel-Cell type required. See VI. “Batteries and Charging.”

4Other colors available through special order.

NOTE: All specifications subject to change without notice.

www.pridemobility.com

Legend

V . Y O U R S C O O T E R

TILLER CONSOLE

The tiller console houses all of the controls needed to drive your scooter. See figure 5.

WARNING! Do not expose the tiller console to moisture. In the event that the tiller console does become exposed to moisture, do not attempt to operate your scooter until the tiller console has dried thoroughly.

	BATTERY CONDITION METER	SPEED ADJUSTMENT DIAL
	STATUS LED	HAZARD LIGHT SWITCH
	KEY SWITCH	HAZARD LIGHT SWITCH
	KEY SWITCH
	RUNNING LIGHTS SWITCH	HORN BUTTON
	HORN BUTTON	TURN SIGNAL BUTTON (RIGHT)
	TURN SIGNAL BUTTON (LEFT)	TURN SIGNAL BUTTON (RIGHT)
	TURN SIGNAL BUTTON (LEFT)
	HEADLIGHT SWITCH	THROTTLE CONTROL LEVER
	THROTTLE CONTROL LEVER	(FORWARD)
	THROTTLE CONTROL LEVER
	(REVERSE)	POWER SEAT SWITCH (OPTIONAL)
		POWER SEAT SWITCH (OPTIONAL)

Figure 5. Tiller Console

Key Switch

!Insert the key into the key switch and turn it clockwise to power up (turn on) your scooter.

!Turn the key counterclockwise to power down (turn off) your scooter.

WARNING! If the key is turned to the off position while your scooter is in motion, the electronic brakes engage and your scooter will come to an abrupt stop!

Throttle Control Lever

This lever allows you to control the forward speed and the reverse speed of your scooter up to the maximum speed you preset with the speed adjustment dial.

!Place your right hand on the right handgrip and your left hand on the left handgrip.

!Use your right thumb to push the right side of the lever to disengage your scooter’s brakes and move forward.

!Release the lever and allow your scooter to come to a complete stop before pushing the other side of the lever to move in reverse.

!When the throttle is completely released, it automatically returns to the center “stop” position and engages your scooter’s brakes.

Speed Adjustment Dial

This dial allows you to preselect and limit your scooter’s top speed.

!The image of the tortoise represents the slowest speed setting.

!The image of the hare represents the fastest speed setting.

Status LED

The Status LED alerts you to electrical problems that may occur with the Legend. The LED remains constantly lit while your scooter is on. If the Legend develops an electrical problem, the status LED will flash a code. See XI. “Basic Troubleshooting” for diagnostic flash codes.

Legend