I X . D I S A S S E M B LY A N D A S S E M B LY
I X . D I S A S S E M B LY A N D A S S E M B LY
6.Unplug both black and white
7.Unplug the
WARNING! Failure to unplug both battery harnesses and the
Figure 17. Battery Harnesses | Figure 18. |
Toggle Latch Release
1.Push in the toggle latch release button while pulling back the toggle latch. See figure 19.
2.Position the toggle latch buckle over the top of the toggle latch. See figure 20.
3.Lower the tiller to the scooter floorboard.
|
|
|
|
|
|
|
| TOGGLE | ||
TOGGLE | TOGGLE |
| LATCH |
|
| |||||
| ||||||||||
LATCH |
|
|
|
|
|
| BUCKLE | |||
|
|
|
|
| LATCH |
| ||||
| ||||||||||
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
| RELEASE |
|
|
|
|
|
|
|
|
|
| BUTTON |
|
|
|
|
|
|
|
| |||||||
Figure 19. Toggle Latch (Latched) |
|
| Figure 20. Toggle Latch (Unlatched) | |||||||
Frame Separation
1.Push back on the seat post to pivot the scooter’s rear section backwards until the rear section is standing vertically on its rear bumper. See figure 21.
2.Lift the front section up until the lower pegs are no longer in the slots. See figure 22.
3.Carefully move the front section away from the rear section.
Figure 21. Frame Positioning | Figure 22. Separating The Frame Sections |
ASSEMBLY
1.Position the front and rear sections of your scooter as showninfigure 23.
2.Align the lower slots of the front section with the cor- responding pegs on the front of the rear section.
WARNING! Position the
when pivoting the rear section forward. See figure 24.
3.Holding the seat post, slowly pivot the rear section forward until the curved locking brackets are fully con- nected onto the top rear pegs. See figure 24.
4.Raise the tiller.
5.Secure the toggle latch. See figure 19.
!Lower the toggle latch buckle.
!Push back on the toggle latch so it locks into place.
6.Connect the
7.Replace the shroud.
8.Replace the seat and secure it into place.
Figure 23. Frame Sections
Figure 24. Frame Lockup
36 | www.pridemobility.com | Legend | Legend | www.pridemobility.com | 37 |