X I . C A R E A N D M A I N T E N A N C E
LIGHT BULB REPLACEMENT
The scooter’s light bulbs are easily replaceable. Do not use regular
NOTE: Use only
1.Remove the light cover.
2.Gently remove the bulb by pulling it straight out.
3.Insert a new bulb of the same wattage.
4.Replace the light cover.
NYLON LOCK NUT REPLACEMENT
Any nylon insert lock nut removed during the periodic maintenance, assembly or disassembly of the scooter must be replaced with a new nut. Nylon insert lock nuts should not be reused as it may cause damage to the nylon insert, resulting in a less secure fit. Replacement nylon insert lock nuts are available at local hardware stores or through your authorized Pride Provider.
STORING YOUR SCOOTER
If you plan on not using your scooter for an extended period of time, it is best to:
1.Fully charge its batteries prior to storage.
2.Disconnect the batteries from the scooter.
3.Store your scooter in a warm, dry environment.
4.Avoid storing your scooter where it will be exposed to temperature extremes.
WARNING! Always protect batteries from freezing temperatures and never charge a frozen battery. Charging a frozen battery may reselt in damage to the battery.
Batteries that are regularly and deeply discharged, infrequently charged, stored in extreme temperatures, or stored without a full charge may be permanently damaged, causing unreliable performance and limited service life. It is recommended that you charge the scooter batteries periodically throughout periods of prolonged storage to ensure proper performance.
You may wish to place several boards under the frame of your scooter to raise it off of the ground during periods of prolonged storage. This takes the weight off the tires and reduces the possibility of flat spots developing on the areas of the tires contacting the ground.
DISPOSAL OF YOUR SCOOTER
Your scooter must be disposed of according to applicable local and national statutory regulations. Contact your local waste disposal agency or authorized Pride Provider for information on proper disposal of packaging, metal frame components, plastic components, electronics, and batteries.
X I I . W A R R A N T Y
THREE-YEAR LIMITED WARRANTY
For three (3) years from the date of purchase, Pride will repair or replace at our option to the original purchaser, free of charge, any of the following parts found upon examination by an authorized representative of Pride to be defective in material and/or workmanship:
Structural Frame Components, Including:
! | Main Frame | ! | Fork |
! | Seat Post | ! | Tiller Frame |
THREE-YEAR PRORATA WARRANTY
! Transaxle | ! Motor Brake (electronic function ONLY) ! Brake |
These components will be prorated on the following schedule:
!First year: 100% replacement of parts cost
!Second year: 67% replacement of parts cost
!Third year: 50% replacement of parts cost
NOTE: If there is an increase in the operational noise level in the transaxle, the warranty does not apply. An increase in operational noise level usually occurs due to abusive and excessive strain on the scooter.
ONE-YEAR LIMITED WARRANTY
For one (1) year from the date of purchase, Pride will repair or replace at our option to the original purchaser, free of charge, any of the following parts found upon examination by an authorized representative of Pride to be defective in material and/or workmanship:
! Bearings | ! Bushings | |
! Rubber Components | ! Plastic components except body | |
Also, electronic assemblies including: | ||
! | Electronic Controllers | ! Chargers |
! | Harnesses | ! Any other electrical subassembly |
SIX-MONTH WARRANTY
The battery is covered by a separate
RECONDITIONED UNITS WARRANTY
All reconditioned units are covered by a
WARRANTY EXCLUSIONS
This warranty does not extend to those items which may require replacement due to normal wear and tear.
! | ABS Plastic shrouds | ! | Motor brushes | ! | Upholstery and seating |
! | Brake Pads | ! | Tires and tubes | ! | Fuses/Bulbs |
42 | www.pridemobility.com | Legend | Legend | www.pridemobility.com | 43 |