Invacare Pronto M71 manual Dealer/Invacare for Service

Page 28

SECTION 4—SAFETY INSPECTION/TROUBLESHOOTING

SYMPTOM

PROBABLE CAUSE

SOLUTIONS

 

 

 

Battery indicator flashes the charge

Battery failure.

Check batteries for shorted cell.

level is low - immediately after

 

Replace if necessary.

recharge.

 

 

 

Malfunctioning battery charger.

Contact Dealer/Invacare for Service.

 

Electrical malfunction.

Contact Dealer/Invacare for Service.

 

 

 

Battery indicator flashes the charge

Batteries not charged.

Have charger checked.

level is low - too soon after being

 

 

recharged.

Weak batteries.

Replace batteries if necessary. Contact

 

 

Dealer/Invacare for Service.

 

 

 

Motor “chatters” or runs irregular.

Electrical malfunction.

Contact Dealer/Invacare for Service.

 

 

 

Joystick erratic or does not respond

Damaged motor coupling.

Contact Dealer/Invacare for Service.

as desired.

 

 

 

Electrical malfunction.

Contact Dealer/Invacare for Service.

 

Controller programmed

Contact Dealer/Invacare to have

 

improperly.

controller reprogrammed.

 

 

 

Wheelchair does not respond to

Poor battery terminal

Have terminals cleaned.

commands.

connection.

 

 

 

 

Power indicator Off - even after

Electrical malfunction.

Contact Dealer/Invacare for Service.

recharging.

 

 

 

 

 

Pronto® M94™

28

Part No. 1122145

Image 28
Contents Pronto M94 Dealer This manual Must be given to the user of the productReference Documents Reference DocumentsManual Part Number Table of Contents Wheelchair Operation ArmsSeat Footboard AssemblyFront Riggings Limited Warranty Register Your ProductSHROUD/WHEELS BatteriesSpecial Notes Signal Word MeaningWheelchair TIE-DOWN Restraints and Seat Restraints Special Notes Label Locations Typical Product Parameters InchGeneral Guidelines Controller Settings/Repair or ServiceOperation Information General Guidelines Batteries AccessoriesCharging Batteries Weight Training Weight LimitationGrounding Instructions Rain TestEMI Information EMI InformationEMI Information SAFETY/HANDLING of Wheelchairs Stability and BalanceCoping With Everyday Obstacles Lifting/Stairways Rear Forks Front Forks Transferring to and From Other Seats Reaching, Leaning and Bending ForwardReaching and Bending Backward Reaching, Leaning and Bending ForwardSafety Inspection Checklists Safety INSPECTION/ TroubleshootingInspect/Adjust Initially Inspect/Adjust Monthly Inspect/Adjust WeeklyInspect/Adjust Periodically Troubleshooting Mechanical Troubleshooting ElectricalSolutions SPJ+, SPJ+ w/PSS or SPJ+ w/ACC JoysticksNumber Error Code Possible Solution Display Description DefinitionSymptom Probable Cause Solutions MPJ+, PSR+, PSF+ Joysticks or DisplaysDealer/Invacare for Service Checking Battery Charge Level DON’TTurning the Power On/Off Wheelchair OperationOperating the Wheelchair Joystick ActionUsing the Joystick to Drive the Wheelchair Movement ActionOn/Off Button SpeedometerService Indicator Speed Control ButtonsJoystick Charger/Programming InputDrive Select Toggle Switch MPJ+ Joystick Switches and IndicatorsInformation Gauge Display Speed Control LCD Display ScreensLCD Display LCD Display Screens Driving Programmable Mono Port 1/2 or External Mode Switch IconMode Switch Remote On/Off SwitchMemory Card Slot Repositioning the Joystick Preparing the Joystick for UseAsba Seat Model Van Seat Model 10 Repositioning the Joystick Asba Seat ModelDisconnecting/Connecting the Joysticks SPJ+ Joysticks13 Disconnecting/Connecting the Joysticks MPJ+ Joysticks MPJ+ JoysticksInstalling/Removing Flip Back Armrests InstallingArms RemovingAdjusting Flip Back Armrests AdjustingPositioning Flip Back Armrests for User Transfer Positioning Flip Back Armrests for UseAngle Adjusting Van Seat ArmrestsHeight Adjusting Van Seat Armrests Adjusting the Back Angle Adjusting the HeadrestSeat Adjustable Seat Back Angle Asba Model Removing/Installing the Seat Assembly Adjusting the Seat Height Adjusting Seat Position on Seat Frame Asba ModelAdjusting Seat Depth Van Seat Only Do not UseAdjusting Seat Depth Van Seat Only Replacing the Seat Positioning StrapReplacing the Seat Positioning Strap Asba Model Footboard Assembly Removing/Installing the Footboard AssemblyAdjusting the Footboard Assembly Removing/Installing the Footboard AssemblyAdjusting the Footboard Assembly Depth DepthInstalling/Removing Front Riggings Front RiggingsModel PHWH93 Adjusting Footrest HeightModel PH904A and PHAL4A Replacing Heel Loops Raising/Lowering Elevating Front RiggingsFront Riggings Adjusting/Replacing Telescoping Front Rigging Supports Asba Standard Position Inch OUT Inches OUTAdjusting/Replacing Telescoping Front Rigging Supports Asba SHROUD/WHEELS Removing/Installing the ShroudsReplacing the Flat Free Tires on the Wheel Rim Removing/Installing the Shrouds Engaging/Disengaging Motor Release LeverReplacing Front/Rear Caster Assemblies Engaging/Disengaging Motor Release LeverAdjusting Forks Adjusting ForksBatteries Installing/Removing the Batteries Tool QTY CommentsInstalling/Removing the Batteries Connecting/Disconnecting the Battery Wiring Harness Connecting DisconnectingConnecting/Disconnecting the Battery Wiring Harness Charging BatteriesWhen to Charge Batteries SPJ+ JoysticksOn-Board Battery Charger Battery Charger OperationMPJ+ Joystick Charging Indicator Status YellowIndependent Charger Independent ChargerBatteries Limited Warranty USA

Pronto M71 specifications

The Invacare Pronto M71 is a state-of-the-art power wheelchair designed for users seeking enhanced mobility and independence. Known for its compact design, the Pronto M71 is versatile enough for both indoor and outdoor use, making it an ideal choice for individuals with varying mobility needs.

One of the standout features of the Pronto M71 is its advanced SureStep technology. This innovative system allows the wheelchair to navigate over obstacles and transitions smoothly, ensuring users can move confidently across uneven surfaces. The SureStep system features a unique suspension mechanism that helps maintain stability and control, which is particularly beneficial when negotiating ramps or curbs.

The Pronto M71 is powered by a robust drivetrain comprised of strong motors that provide reliable performance. It is equipped with dual motors that enhance maneuverability, allowing the chair to turn on a dime and navigate tight spaces with ease. The wheelchair's rear-wheel drive design further contributes to its stability and straight-line tracking, giving users a sense of security during transit.

Comfort is a top priority for Invacare, and the Pronto M71 is no exception. The chair features adjustable seating systems, providing users with the option to customize their seating to fit their specific needs. This includes adjustable armrests, seat depth, and back height, ensuring maximum comfort for users during extended periods of use.

In terms of safety, the Pronto M71 is designed with thoughtful features that prioritize user protection. The chair comes with anti-tip technology, ensuring stability when navigating slopes or uneven terrain. Additionally, powerful brakes provide dependable stopping performance, giving users confidence in their mobility.

Another notable characteristic of the Pronto M71 is its user-friendly controls. The joystick controller is intuitive and easy to operate, allowing for effortless navigation. The buttons are designed for simplicity, making it accessible for users of all ages and abilities.

The Pronto M71 also supports various accessories, including trays, cup holders, and custom seating, making it a highly adaptable solution to meet individual user preferences.

Overall, the Invacare Pronto M71 power wheelchair is a remarkable blend of technology, comfort, and safety. Whether users are navigating their home or exploring the outdoors, the Pronto M71 offers the performance and reliability needed to enjoy an active and independent lifestyle. Its innovative features and focus on user experience make it a top choice in the market for power wheelchairs.