Invacare Lynx L-4 manual Removing/Installing the Batteries

SECTION 10—BATTERIES

Installing

1.Install the two new batteries into the battery box.

2.Secure the thermal switch to the side of the left battery using tape*.

*NOTE: The thermal switch needs to be well secured and in direct contact with the side of the battery. Service tape is available as a service part and is the recommended solution. As an alternate, a heavy duty “duct” styled tape can be used. If “duct” styled tape is used, wrapping the tape completely around the battery with minimal overlap will provide the best adhesion.

3.Connect the wiring harness to the batteries in the following order (Detail “B” of FIGURE 10.3):

A.NEGATIVE (-) BLACK battery cable to the NEGATIVE (-) battery terminal on the left battery.

B.POSITIVE (+) RED battery cable to the POSITIVE (+) battery terminal on the right battery.

C.WHITE battery cable (Jumper) to the POSITIVE (+) battery terminal on the left battery and the NEGATIVE (-) battery terminal on the right battery.

4.Replace the top of the battery box and secure with the twelve mounting screws (Detail “A” of FIGURE 10.3). Securely tighten.

5.Reinstall the battery box on to the scooter frame. Refer to Removing/Installing the Battery Box on page 38.

6.Reinstall the seat. Refer to Removing/Installing/Adjusting the Padded Seat on page 29 or Removing/Installing the Deluxe Seat on page 31.

Detail “A”

Battery

Box Cover

Battery

Box

NEGATIVE (-)	Detail “B”
BLACK Battery Cable		Battery
NEGATIVE (-)	WHITE Battery Cable	Box Cover
BLACK Battery	(Jumper)	POSITIVE (+)
Terminal		RED Battery
		Terminal
Cables
to
Thermal
Switch
(not		POSITIVE (+)
shown)		RED Battery
		Cable

Battery	Right Battery
	Left Battery
Box

FIGURE 10.3 Removing/Installing the Batteries

Lynx™L-3 & Lynx L-4 40 Part No. 1143205