SECTION
SECTION 11—TRANSPORTING
WARNING
After any adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, turn power off and remove key from ignition.
DO NOT lift the scooter by the rear shroud - otherwise damage to the scooter may occur.
Transporting the Scooter
NOTE: For this procedure, refer to FIGURE 11.1 on page 44.
Disassembling
1.Turn power off and remove the key from the ignition.
2.Remove the basket.
3.Remove the seat. Refer to Removing/Installing the Seat on page 30.
4.Remove the battery box. Refer to Removing/Installing the Battery Box on page 38.
5.Hold the seat post with one hand (Detail “A”).
6.With the other hand, push the release lever to the rear of the scooter.
7.Lift the seat post to separate the front frame assembly from the rear frame assembly (Detail “B”).
8.Fold tiller down to lowest locked position. Refer to Adjusting the Tiller Angle on page 34.
Assembling
1.Unfold tiller. Refer to Adjusting the Tiller Angle on page 34.
2.Pivot the rear frame assembly until it is vertical (Detail “C”).
3.Hold the seat post and align the curved locking brackets on the front frame assembly with the bar on the rear frame assembly.
4.While holding the seat post, slowly pivot the rear frame assembly forward until the release lever locks (Detail “B”).
5.Install the battery box. Refer to Refer to Removing/Installing the Battery Box on page 38.
6.Install the seat. Refer to Removing/Installing the Seat on page 30.
7.Install the basket.