Invacare Lynx L-4 manual Accessories, Installing/Removing the Accessory Tube

Page 45

SECTION 12—ACCESSORIES

SECTION 12—ACCESSORIES

WARNING

After ANY adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.

Before performing any maintenance, adjustment or service, turn power off and remove key from ignition.

NOTE: The crutch/cane holder, safety flag, rear mounted basket and oxygen holder all install into the accessory tubes; ONLY one of these may be installed at a time.

Installing/Removing the Accessory Tube

NOTE: For this procedure, refer to FIGURE 12.1.

Installing

1.Position the accessory tube onto the seat frame.

2.Secure the accessory tube to the seat frame using the mounting screw.

3.Remove the mounting knob from the accessory tube (Detail “A”).

4.Remove the cap from the accessory tube.

Removing

1.Remove the mounting screw securing the accessory tube to the seat frame.

2.Remove the accessory tube from the seat frame.

Mounting Screw

Accessory Tube

DETAIL “A”
	Mounting
Cap	Knob

FIGURE 12.1 Installing/Removing the Accessory Tube

Part No. 1143205

45

Lynx™L-3 & Lynx L-4

Image 45

Contents Dealer This manual Must be given to the user of the scooter LynxL-3 & Lynx L-4LynxL-3 & Lynx L-4 Table of Contents Register Your Product Product Registration Form Fold here Cut Along Line Special Notes Signal Word MeaningTIE-DOWN Restraints and Seat Restraints Seat Positioning StrapSpecial Notes Lynx L-3 Lynx L-4 Typical Product ParametersSerial Number Label Label LocationsGeneral Guidelines Repair or Service InformationOperation Information ImmediatelyGeneral Guidelines Electrical Weight Limitation Weight TrainingBatteries Rain TestEMI Information EMI InformationEMI Information Stability and Balance SAFETY/HANDLING of Powered ScootersEscalators StairwaysSafety Inspection Safety Inspection ChecklistsInspect/Adjust Initially Inspect/Adjust Monthly Inspect/Adjust WeeklyInspect/Adjust Periodically Suggested Maintenance Procedures Maintenance and TroubleshootingSymptom Probable Cause Solution TroubleshootingNumber of Flashes Problem Solution Service Indicator Error CodesResetting the Circuit Breaker Resetting the Circuit BreakerControl Panel Operation of the Powered ScooterControl Panel Operating the ScooterOperation of the Powered Scooter Engaging/Disengaging the Brake Release Lever Engaging/Disengaging the Brake Release LeverInstalling Removing/Installing the SeatSeat and Arms RemovingAdjusting Seat Height Adjusting Seat HeightAdjusting the Arm Width Adjusting 90 Seat SwivelReplacing Armrest Pads Adjusting the Arm WidthAdjusting the Tiller Angle Tiller AdjustmentWheels and Casters Removing/Installing the Drive WheelsRemoving/Installing the Drive Wheels Removing/Installing the Front WheelBatteries Recommended Battery TypeRecommended Battery Type Removing/Installing the Battery BoxRemoving/Installing the Battery Box Removing/Installing the BatteriesRemoving/Installing the Batteries Charging the Batteries Charging the Batteries Transporting the Scooter TransportingDisassembling AssemblingTransporting the Scooter Installing/Removing the Accessory Tube AccessoriesInstalling/Removing the Crutch/Cane Holder Installing/Removing the Crutch/Cane HolderInstalling/Removing/Using the Walker Holder Installing/Removing the Safety FlagUsing the Walker Holder Installing/Removing the Walker HolderInstalling/Removing the Rear Mounted Basket Installing/Removing the Rear Mounted BasketAccessories Limited Warranty Product Made Taiwan Distributed by Invacare