Invacare Lynx L-4 manual Installing/Removing the Crutch/Cane Holder

Page 46

SECTION 12—ACCESSORIES

Installing/Removing the Crutch/Cane Holder

WARNING

The installation of the crutch/cane holder onto the back of the scooter seat signifi- cantly increases the length of the scooter. When turning the scooter or swiveling the scooter seat, it is important to take note of this increased length - otherwise, injury and/or damage to the surrounding property may result.

NOTE: For this procedure, refer to FIGURE 12.2.

Installing

1.Install the crutch/cane holder into the accessory tube located on the back of the seat.

2.Install the mounting knob to secure the crutch/cane holder in place. Securely tighten.

3.Align the slot on the base with the hook on the crutch/cane holder and slide base down into position.

Removing

1.Remove the crutch/cane holder from the accessory tube.

2.Remove the mounting knob that secures the crutch/cane holder in place.

3.Remove the crutch/cane holder from the accessory tube.

Crutch Cane

Holder

Mounting Knob

Hook

Base

Accessory Tubes

FIGURE 12.2 Installing/Removing the Crutch/Cane Holder

Lynx™L-3 & Lynx L-4

46

Part No. 1143205

Image 46

Contents LynxL-3 & Lynx L-4 Dealer This manual Must be given to the user of the scooterLynxL-3 & Lynx L-4 Table of Contents Register Your Product Product Registration Form Fold here Cut Along Line TIE-DOWN Restraints and Seat Restraints Signal Word MeaningSpecial Notes Seat Positioning StrapSpecial Notes Typical Product Parameters Lynx L-3 Lynx L-4Label Locations Serial Number LabelOperation Information Repair or Service InformationGeneral Guidelines ImmediatelyGeneral Guidelines Electrical Batteries Weight TrainingWeight Limitation Rain TestEMI Information EMI InformationEMI Information SAFETY/HANDLING of Powered Scooters Stability and BalanceStairways EscalatorsSafety Inspection Checklists Safety InspectionInspect/Adjust Initially Inspect/Adjust Weekly Inspect/Adjust MonthlyInspect/Adjust Periodically Maintenance and Troubleshooting Suggested Maintenance ProceduresTroubleshooting Symptom Probable Cause SolutionService Indicator Error Codes Number of Flashes Problem SolutionResetting the Circuit Breaker Resetting the Circuit BreakerOperation of the Powered Scooter Control PanelOperating the Scooter Control PanelOperation of the Powered Scooter Engaging/Disengaging the Brake Release Lever Engaging/Disengaging the Brake Release LeverSeat and Arms Removing/Installing the SeatInstalling RemovingAdjusting Seat Height Adjusting Seat HeightAdjusting 90 Seat Swivel Adjusting the Arm WidthAdjusting the Arm Width Replacing Armrest PadsTiller Adjustment Adjusting the Tiller AngleRemoving/Installing the Drive Wheels Wheels and CastersRemoving/Installing the Front Wheel Removing/Installing the Drive WheelsRecommended Battery Type BatteriesRemoving/Installing the Battery Box Recommended Battery TypeRemoving/Installing the Batteries Removing/Installing the Battery BoxRemoving/Installing the Batteries Charging the Batteries Charging the Batteries Disassembling TransportingTransporting the Scooter AssemblingTransporting the Scooter Accessories Installing/Removing the Accessory TubeInstalling/Removing the Crutch/Cane Holder Installing/Removing the Crutch/Cane HolderInstalling/Removing the Safety Flag Installing/Removing/Using the Walker HolderInstalling/Removing the Walker Holder Using the Walker HolderInstalling/Removing the Rear Mounted Basket Installing/Removing the Rear Mounted BasketAccessories Limited Warranty Product Made Taiwan Distributed by Invacare