Invacare FDX-CG, FDX-MCG user manual Positioning the Wheelchair in the Vehicle, Side View

Page 63

7 TRANSPORT READY OPTION (TRRO)

Positioning the Wheelchair in the Vehicle

￿ WARNING

This wheelchair MUST be in a forward facing position during travel in a motor vehicle.

The recommended clear zones for wheelchair seated occupants restrained by BOTH pelvic and upper torso belt(s) and ONLY by a pelvic belt are shown in the diagrams and described below.

Frontal Clear Zones (FCZ) need to be LARGER when upper torso belt(s) are NOT used. The rear clear zone of 16-inches is measured from the rearmost point on an occupant’s head.

The frontal clear zone is measured from the frontmost point on an occupant’s head and is 26-inches with pelvic and upper- torso belt(s) and 37-inches with ONLY a pelvic belt.

The frontal clear zone may not be achievable for wheelchair-seated drivers.

The estimated seated height (HHT) from the ground or floor to the top of the wheelchair-seated occupant’s head ranges from approximately 47-inches for a small adult female to about 61-inches for a tall adult male

.

(Frontal Clear Zone)

16in.FCZ

Side View

HHT

8in.

8in.

16in.FCZ (Frontal Clear Zone)

Top View

Part No 1163181

63

Invacare® FDX®

Image 63
Contents Invacare FDX Contents Label Locations Technical Data Motor LOCKS/WHEEL Locks SETUP/MAINTENANCE Troubleshooting General SymbolsReference Documents Global Limited Warranty Excluding CanadaGeneral Canada Limited Warranty General Guidelines SafetyDriving Operation Information SetupSafety Stairways and Escalators Repair or Service Information Safety/Handling Safety Stability and Balance Do not stand on the frame of the wheelchair Coping with Everyday Obstacles Coping with Everyday ObstaclesReaching, Leaning and Bending Forward Footplates and Front RiggingReaching, Bending Backward Transferring To and From Other Seats Front ViewTop View Storage Electrical Batteries Electrical Grounding InstructionsElectrical Charging Batteries Weight Training Weight LimitationElectromagnetic Interference EMI From Radio Wave Sources Powered Wheelchair Electromagnetic Interference EMI Safety Label Locations Label located under the front shroud Wheelchairs without TrroWheelchairs with Running Lights Wheelchairs with TrroTypical Product Parameters Models Overall DimensionsWheels SeatWeight Preparing the Joystick for Use Wheelchair OperationOperating the Wheelchair Turning the Power On/Off SPJ+ JoysticksMPJ+ Joystick  For this procedure, refer to on Using the Joystick to Drive the WheelchairRear Wheelchair Front Wheelchair *The mode button is only present on SPJ+ w/ACC joystick On/Off Button SpeedometerSpeed Control Buttons Information Gauge Display Service IndicatorJoystick Charger/Programming InputOn/Off Drive Select Toggle Switch MPJ+ Joystick Switches and IndicatorsLCD Display Screens Speed ControlLCD Display Clock Driving Screen User Settings Set Date and Time Battery Voltage User SettingsIcon Description Remote On/Off Switch Programmable Mono Ports 1 and 2 with External Mode SwitchMode Switch When to Charge BatteriesMemory Card Slot SPJ+, SPJ+ w/PSS and SPJ+ w/ACC Joysticks Display Screen SPJ+, SPJ+ w/PSS and SPJ+ w/ACC JoysticksCharging Batteries Description and Use of Battery Chargers Mini-Display DisplayRunning Lights Through MPJ+ Joystick Running Lights Through Single Function SwitchSingle Function Switch Running LightsDisengaging/Engaging Motor Lock Levers Motor Locks/Wheel LocksDisengaging/Engaging Motor Lock Levers Disengaging/Engaging Wheel Lock Levers Accessories WarningTransport Ready Option Trro About Transport Ready Packages Compliance Information SpecificationsSide View Positioning the Wheelchair in the VehicleSecuring the Wheelchair Securement PointsSecuring the Occupant Wheelchair-Anchored Belts Detail a Pelvic Belt Vehicle-Anchored Belts Rear ViewSeating System Positioning Belts Positioning Belts Setup/Delivery Inspection Setup/MaintenanceInspect/Adjust Weekly User/Attendant Inspection ChecklistsInspect/Adjust Periodically Inspect/Adjust MonthlySix Month Inspection Service InspectionSETUP/MAINTENANCE Inspect/Adjust Every 18 Months Batteries Using the Proper Batteries For Wheelchairs Using GP34 BatteriesTool QTY Removing/Installing the BatteriesRemoving/Installing the Batteries Removing/Installing the Front BatteryRemoving the Rear Shroud Removing/Installing the Rear BatteryRemove the rear battery from the wheelchair base frame Detail a Disconnecting Battery Cables Replacing the Batteries and/or Battery CablesPerform on one battery at a time Connecting Battery CablesReplacing the Batteries and/or Battery Cables Front BatteryAnti-Tippers Anti-TippersAdjusting Forks Adjusting ForksRepositioning Joystick Repositioning JoystickDisconnecting Disconnecting/Connecting the JoysticksMPJ+ Joysticks Disconnecting/Connecting the Joysticks MPJ+ JoysticksElectrical SPJ+, SPJ+ w/PSS or SPJ+ w/ACC Joysticks Driving PerformanceDisplay Description Definition Service Indicator Light MPJ+, PSR+, PSF+ Joysticks or Displays Symptom Probable Cause SolutionsCtrl not Connected Improperly DON’T Checking Battery Charge LevelInvacare FDX Invacare FDX USA