Invacare FDX-MCG, FDX-CG user manual Removing/Installing the Rear Battery, Removing the Rear Shroud

8 SETUP/MAINTENANCE

Removing/Installing the Rear Battery

For this procedure, refer to FIGURE 2 and FIGURE 3 on page 82. Reverse this procedure to install the rear battery.

1.Remove the two thumb screws securing the rear shroud to the rear shroud stand offs (FIGURE 2).

2.Remove the rear shroud from the wheelchair base frame.

Take note of position and orientation of the tie-wraps and wiring bundles before cutting necessary tie-wraps and repositioning the wiring bundles.

3.Locate the two wiring bundles, one on each side of the controller and if necessary, cut the tie-wraps securing the wiring bundles to the controller bracket.

Mounting Screw

Stand Offs

Wheelchair Base Frame

Stand Offs

Mounting Screw

Mounting Screws	Wheelchair Base Frame
Rear Shroud	Controller Bracket
	FIGURE 2 Removing the Rear Shroud

Invacare® FDX® 80 Part No 1163181