Invacare 65400, 65500 Assembling Spartan For Use Figure, Install tire. Perform the following

Page 6

REMOVING/

INSTALLING THE

PLUNGER

ASSEMBLY

-STEPS 2 AND 9

Rear Frame

REMOVING/SECURING THE

BRAKE WIRE STOP

- STEPS 3 AND 8

LipPlunger

Flat

Screwdriver

Plunger

Assembly

Insert

Slot Opening

Flat

Screwdriver

Brake Wire Stop

Slot

DISASSEMBLING/ASSEMBLING THE PLUNGER

ASSEMBLY - STEPS 4 AND 7

 

 

Brake

 

Plunger

Spring

Wire Slot Brake

Slot

 

Wire

Opening

 

 

 

 

Stop

 

REMOVING/INSERTING

THE BRAKE CABLE

- STEPS 5-6

Brake

Cable

Rear Frame

Insert

FIGURE4 -REPLACINGSPARTANCANESANDBRAKES-REPLACINGSPARTANBRAKES

Assembling Spartan For Use (FIGURE 5)

NOTE: The Spartan rollator should only be assembled AFTER replacing spartan brakes. Refer to REPLAC- ING SPARTAN BRAKES in this procedure of the in- struction sheet.

1.Install tire. Perform the following:

A.Position the tire so the mounting holes are aligned with the mounting holes in the rollator leg.

B.Install the screw from the inside of the rollator, through both sets of mounting holes.

C.Secure the tire to the rollator with the locknut. Tighten securely.

D.Install the cap covers over the screw and locknut.

2.Perform one (1) of the following:

INSTALLING CANE KIT - Install the push handle. Per- formthefollowing:

A.Remove the hex bolt, washer and locknut securing thehandbraketothepushhandle.

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Safety Summary Replacing Sprint Canes and Brakes FigureInstall the NEWbrake wire. Perform the following Securely tighten the locknutNEW hand brake Disassembled Assembled Preparing Spartan for Brake Replacement Figure Replacing Spartan Canes and BrakesRemoving/Installing The Spartan Brake Pad Only Figure Assemble the plunger assembly. Perform the followingReplacing Spartan Brakes Figure Install tire. Perform the following Assembling Spartan For Use FigureInstalling Brake KIT After 3/8/00 Install NEW hand brake Push the NEW hand brake onto the push handleAdjusting Cable Brake Handle Before 3/8/00 Adjusting Sprint Spartan Hand BrakesAdjusting Cable Brake Handle Before 3/7/00 Loosen the brake handle adjustment nut by turningTo decrease tension, turn the cable adjuster unit Loosen the cable brake adjuster unit locknutRetighten the cable adjuster unit locknut Do one 1 of the followingAdjusting Stingray and Stargazer Push Handle Figure Replacing Stingray and Stargazer Brakes FigureAdjusting Caster Housing Adjusting Stingray and Stargazer Hand Brakes FigureAdjusting Hand Brake Loosen the hand brake adjustment nut by turningRemoving/Installing The Stingray Brake Pad Figure Test brake, if necessary adjust brakeBly and securely tighten the set screw
Top Page Image Contents