Rollator Cane and Brake Replacement
Assembly, Installation and Operating Instructions
SAVE THESE INSTRUCTIONS
NOTE: Check ALL parts for shipping damage. If shipping damage is noted, DO NOT use. Contact Carrier/Dealer for further instruction.
PART DESCRIPTION
NUMBER
SPARTAN - 65420
1076187 | Cane Kit - Left |
1076188 | Cane Kit - Right |
1076189 | Brake Kit - Left (Before 3/7/00) |
1076190 | Brake Kit - Right (Before 3/7/00) |
1096765 | BrakeKit(After 3/8/00) |
SPRINT - 65400
1076192 | Cane Kit - Left |
1076193 | Cane Kit - Right |
1076194 | Brake Kit - Left (Before 3/7/00) |
1076195 | Brake Kit - Right (Before 3/7/00) |
1096767 | BrakeKit(After 3/8/00) |
STINGRAY - 65500
1076182 Cane Kit
1076184 BrakeKit
STARGAZER - 65600
1076183 Cane Kit
1076184 BrakeKit
Note: Cane kits contain a push handle with hand grip, and hand brake already attached.
SAFETY SUMMARY
The following recommendations are made for the safe replacement of the Rollator Canes and Brakes:
GENERAL WARNINGS
DO NOT install this kit without first reading and understanding this instruction sheet. If you are unable to understand the Warnings, Cautions and Instructions, con- tact a healthcare professional, dealer or technical personnel if applicable before attempting to install this kit - otherwise, injury or damage may occur.
A physical/occupational therapist should assist in the placement and positioning of the hand grips for maximum support and correct brake activation. Be sure the rollator is properly balanced BEFORE using.
Care should be taken to ensure that ALL hand and height adjustments are secure, and that casters and moving objects are in good working order before using this or any mobility aid.
SAFETY SUMMARY (CONTINUED)
INSTALLATION WARNINGS
SPRINT (65400) and SPARTAN (65420) MODELS - The rollator height can ONLY be adjusted where the push handle is textured (FIGURE 4).
After installation and BEFORE use, ensure that ALL attaching hardware is securely tightened.
REPLACING SPRINT CANES AND BRAKES (FIGURE 1)
1.Remove the EXISTING brake wire. Perform the fol- lowing:
A.Loosen, but DO NOT remove the phillips screw securing the brake wire to the brake wire clamp.
B.Remove the brake wire clamp and set aside.
C.Pull wire through the hole in the brake.
D.Remove the spring and set aside.
E.Pull wire through cable adjuster unit. If necessary, loosen the cable adjuster unit locknut.
2.Pull brake cable UP to remove from side frame. If necessary, cut
3.Perform one (1) of the following:
INSTALLING CANE KIT - Remove EXISTINGpush handle.
A.Rotate adjustment lever counterclockwise to loosen. DO NOT remove.
B.Pull UP on the push handle to remove.
INSTALLING BRAKE KIT (BEFORE 3/7/00) - Re- move EXISTING hand brake.
A.Remove the hex bolt, washer and locknut secur- ing the hand brake to the push handle.
B.Remove the hand brake.
INSTALLING BRAKE KIT (AFTER 3/8/00) - Re- move EXISTING hand brake.
A.Remove EXISTING hand grip from the push handle and discard.
1