Cisco Systems OL-31386-01 specifications Preparing the Access Point

Page 12

Note You cannot edit or query any access point using the controller CLI if the name of the access point contains a space.

Note Make sure that the controller is set to the current time. If the controller is set to a time that has already occurred, the access point might not join the controller because its certificate may not be valid for that time.

Access points must be discovered by a controller before they can become an active part of the network. The access point supports these controller discovery processes:

•Layer 3 CAPWAP discovery—Can occur on different subnets than the access point and uses IP addresses and UDP packets rather than MAC addresses used by Layer 2 discovery.

•Locally stored controller IP address discovery—If the access point was previously joined to a controller, the IP addresses of the primary, secondary, and tertiary controllers are stored in the access point’s non-volatile memory. This process of storing controller IP addresses on an access point for later deployment is called priming the access point. For more information about priming, see the “Performing a Pre-Installation Configuration” section on page 13.

•DHCP server discovery—This feature uses DHCP option 43 to provide controller IP addresses to the access points. Cisco switches support a DHCP server option that is typically used for this capability. For more information about DHCP option 43, see the “Configuring DHCP Option 43 and DHCP Option 60” section on page 39.

•DNS discovery—The access point can discover controllers through your domain name server (DNS). For the access point to do so, you must configure your DNS to return controller IP addresses in response to CISCO-CAPWAP-CONTROLLER.localdomain, where localdomain is the access point domain name. Configuring the CISCO-CAPWAP-CONTROLLER provides backwards compatibility in an existing customer deployment. When an access point receives an IP address and DNS information from a DHCP server, it contacts the DNS to resolve CISCO-CAPWAP-CONTROLLER.localdomain. When the DNS sends a list of controller IP addresses, the access point sends discovery requests to the controllers.

Preparing the Access Point

Before you mount and deploy your access point, we recommend that you perform a site survey (or use the site planning tool) to determine the best location to install your access point.

You should have the following information about your wireless network available:

•Access point locations.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Cisco Aironet 2700 Series Access Points OL-31386-01 Last Updated March 31 Introduction to the Access Point About this GuideSafety Instructions Important Safety Instructions20A. Statement Configurations UnpackingExternal Antennas Internal Antennas Regulatory DomainsAccess Point Ports and Connectors Access Point Ports and Connections top-2702E ModelAccess Point LED Indicator top-2702I Model 352657 Configuring the Access Point Controller Discovery ProcessPreparing the Access Point Installation Summary Performing a Pre-Installation ConfigurationPre-Installation Configuration Setup Controller Layer 3 devices Cisco Aironet access pointsPage Mounting the Access Point Deploying the Access Point on the Wireless NetworkTroubleshooting Guidelines for Using Cisco Aironet Lightweight Access PointsUsing Dhcp Option Checking the Access Point LEDLED Troubleshooting the Access Point Join Process Page Declarations of Conformity and Regulatory Information For Home or Office USEPage Vcci Statement for Japan 03-6434-6500 Statement 371-Power Cable and AC Adapter Industry Canada Canadian Compliance StatementFrench Translation Access Point Models Page Page Declaration of Conformity for RF Exposure Generic Discussion on RF ExposureThis Device Meets FCC Guidelines for Exposure to Radio Waves MPE Additional Information on RF Exposure Chinese Translation English Translation Operation of Cisco Aironet Access Points in Brazil Declaration of Conformity Statements Portuguese TranslationConfiguring Dhcp Option 43 and Dhcp Option Access Point Specifications Add the option 60 line using the following syntax
Top Page Image Contents